Flash; Exposure Setting Device - Zenza Bronica S2A Instructions Manual

Flash

The Bronica flash terminal accepts a standard connecting cord (German Type P.C.)

Exposure Setting Device

The 120 film allows twelve 6x6 (2 1/4'' x 2 1/4'') exposures. Twenty-four exposures can
be obtained on 220 film.
The upper right picture shows lever position when using the 120 film. Keep pressing
switch lever lock button and move lever until indicator arrow points to ''12'' mark. After
the 12th exposure the film/shutter crank will wind remaining film continuously onto take-
up spool with no resistance. The lower right picture shows lever position when using the
220 film.
Switch lever lock button should be also pressed to move lever until arrow points to ''24''
mark. In this way the film/shutter crank will stop at every number in exposure counter
until 24 before becoming ''free'', allowing the remaining film to be wound up on roll.
(When Model-E is used on your Bronica S2A, set the film setting device on ''S''. The
film/shutter crank will stop at every number in the exposure counter until ''32''. When the
pointer is set on ''F'' the film/shutter crank becomes free, allowing the remaining film to
be wound continuously onto the take-up spool.)
19