Page 1
Please read and keep these instructions For Burco wall mounted boilers 76700 (SKU 444448534), 76702 (SKU 444448546), & 76704 (SKU444448548) Getting the best from your water boiler • Remove any plastic film from the water boiler before use •...
Scale build up can damage any appliance which boiling water passes through. • If the mains lead is damaged, it should be discarded and replaced. Failure to descale your Burco autofill water boiler will invalidate your guarantee. • Turn off and unplug when not in use.
Your water boiler has been supplied with a suitable hose 5 for connection to a only a Burco supply cord must be used. The supply cord may become warm when the drinking water supply. The water supply must have a pressure not exceeding 1000 appliance is in use.
Page 4
After resetting the cut-out replace the front panel and top plastic lid. Reconnect to the mains and switch on at plug/spur and on the front of the unit. If the problem pursists please contact Burco customer helpline. Cleaning WARNING: Disconnect from the electrical supply before cleaning and allow the water boiler to cool.
If dripping has stopped replace front panel and follow descale • Pull front panel forward while lifting hole for tap over base tap fitting. process (see page 8). If tap continues to drip call the Burco customer helpline. • Lift front panel over top of tap fitting.
Genuine replacement Burco parts must only be fitted by a qualified service engineer. If generic non-Burco parts are fitted you may stop your autofill water boiler _____________________________________________________________________________________________ operating safely and in the most efficient manner and may invalidate your warranty.