Table of Contents
Advertisement
2. TECHNICAL DATA
1 NOISE
The typical A-weighted noise level deter-
mined according to EN60745-2-2:
• Sound pressure level (L
• Sound power level (L
• Uncertainty (K):
2 VIBRATION
The vibration total value (tri-axial vector
sum) determined according to EN60745-2-2:
• Work mode: Impact tightening of fasteners
of the maximum capacity of the tool.
• Vibration emission value (a
• Uncertainty (K):
3 RADIATED EMISSION 30-1000 MHZ
Class B
4 Overvoltage category
PRODUCT
PJCD551 CORDLESS
COLLATED SCREW-
DRIVER
JC925(CE)
BATTERY
CHARGER
5 Pollution degree
Pollution degree : degree 4 according to IEC
60664-1 (Both of PJCD551 and JC925(CE)).
3. APPLICATIONS
Tightening screws in plaster board, wood
and thin steel plate.
4. ABOUT PRODUCTION YEAR
This product bears production number in the
body. (Fig.A10) The two digits of the number
from left indicates the production year.
(Example)
10826035D
Year 2010
):
74.9 dB (A)
pA
):
85.9 dB (A)
WA
3 dB (A)
2
):
1.52 m/s
h
2
1.5 m/s
Overvoltage category
Category I
according to
IEC 60664-1
Category II
according to
IEC 60664-1
5. BATTERY INSTRUCTIONS
1. CHARGING
WARNING
• Before removing the Battery pack from the
tool, keep hands away from the Trigger
switch (Fig. A 3).
• Check the rated voltage and use a charger
that provides this voltage.
1 (Fig. D) A Pack cap (Fig. D 13) that is used
to prevent short circuits must be removed
from the terminal of the Battery pack.
(Fig. E) When charging the Battery pack,
remove it from the tool by pushing on its
latches (Fig. E 17) from both sides while
firmly holding the grip of the tool.
2 (Fig. F) Plug the charger into a wall sock-
et.
The red light, a current-carrying indica-
tor, (Fig. F 21) will flash on and off with
two short (Pipi) beep sounds.
WHEN THE ORANGE STANDBY
LIGHT IS LIT
When the Battery pack is hot (after continuous
use or exposure to direct sunlight) the Charger
will automatically switch to standby to protect the
Battery. The orange standby light will be lit until
the Battery's temperature lowers to a safe level.
The Battery will then be charged automatically.
WHEN THE BATTERY PACK IS AT
LOW TEMPERATURE
When the Battery pack is at low temperature, its
charging is automatically suspended until its
temperature increases (higher than 5°C (41°F)),
in order to protect it, even if it is set in the Charg-
er.
Leave the Battery pack at normal temperature in
the room for some time, and then, charge it
again.
11
Advertisement
Table of Contents
