Related Manuals for Indel B sleeping well arctic plus SW2000PLUS
Summary of Contents for Indel B sleeping well arctic plus SW2000PLUS
- Page 1 AIR CONDITIONER ASSEMBLY, MAINTENANCE AND USE INSTRUCTIONS Model Number: SW2000PLUS Serial Number:__________________...
-
Page 2: General Warnings
GENERAL WARNINGS When installing, be sure to carefully follow the instructions given in this manual. The manufacturer declines all responsibilities for damage to equipment or people caused by non-standard system installations or modifications. NOTES When indicated, the right side of the vehicle is the “passenger side” and the left side of the vehicle is the “drivers side”. Contents Page MAIN COMPONENTS –... - Page 3 SLEEPING WELL ARCTIC PLUS...
- Page 4 Description EVAPORATOR CONNECTION KIT CONDENSER CONDENSER MOUNTING KIT COMPRESSOR BOX COMPRESSOR BOX MOUNTING KIT TECHNICAL DATA Cooling Capacity: Up to 6100 BTU Power Consumption: Up to 62A (12V) Functioning with Engine Off: Voltage: 12V DC Refrigerant: R-134A 6 Ventilation Speeds Electronic temperature control with digital control panel Auto –...
- Page 11 Evaporator MUST be mounted as high as possible in the sleeper area. The unit cannot be mounted under the bunk. NOTE: Install return air vents if unit is enclosed in a cabinet.
-
Page 14: Electric Diagram
ELECTRIC DIAGRAM COLOR CODE COLOR CODE COLOR CODE WHITE BROWN GREEN YELLOW BLACK WHITE/RED GRAY RED/BLACK... - Page 16 All 4 buttons must be pressed at the same time...
- Page 17 OPERATION / CONTROL PANEL “SLEEPING WELL ARCTIC PLUS” CAN BE USED BY ACTIVATING THE AIR CONDITIONING OR THE FAN FUNCTION ONLY. CONDITIONING (AC) : TEMPERATURE SET BY USER : AMBIENT TEMPERATURE DETECTED BY PROBE : COMPRESSOR ROTATION SPEED (2500 Rpm) : COMPRESSOR ROTATION SPEED (4000 Rpm) ON/OFF When the system is OFF, press the ON/OFF button (see fig.
- Page 18 ERRORS SHOWN ON THE DISPLAY (AC / FAN) Description Message Symbol Battery Voltage (The battery-saver device has cut out. Voltage has fallen below the value of 10.8V D.C.) Fan Over Current Cut-Out (The condenser or evaporator fan overloads the central control unit above the limit allowed.
- Page 19 REFRIGERANT FILLING PROCEDURE Before charging the system, (by means of the charge fittings on the condenser unit and compressor block) run vacuum cycle for 30 minutes. Disconnect the high-pressure attachment. Charge the system with 17.6oz (500 grams) R-134a into the circuit through the low-pressure attachment.
- Page 20 SYSTEM MAINTENANCE Condenser Compressor Box Evaporator Batteries (Accessory) Spring Visual Inspection Visual Inspection Visual Inspection Visual Inspection Summer Fall Visual Inspection Visual Inspection Visual Inspection Visual Inspection Winter Condenser - Visual Inspection - Core should be clear/free of dirt and debris. Bracket mounting bolts are tight and secure to rear exterior sleeper wall.
- Page 21 Service Parts Breakdown...
- Page 26 Parts Breakdown Part Number Description SW112 Air Vent SW114 Comm Cable between Splitter and Condenser Unit SW146 Manostat SW152 Diffuser Plastic Cover SW153 Evaporator Plastic Cover SW156 Anti-Icing Thermostat SW159 SW166 – Use BT8-8606 G6 Hose (MT) – 13’ 1 ½” (4m) SW167 –...