Table of Contents
Advertisement
•
To prolong the life of the battery, only
charge the battery when the low-battery
light flashes.
NOTE:
Your Nebulizer is equipped with two battery
lamps. Both are positioned on the front of
the unit.
1) A flashing red battery
light, Fig. 6, indicates
proper AC connection
and shows that the
battery is being charged.
NOTE: This lamp has a
second function during oper-
ation. It indicates the lowest
nebulization level, Fig. 10 .
2) If this lamp, Fig. 7 , changes from green
to red during use, the rate of nebulization
will decrease, then cease, indicating that
the battery needs to be charged. If this
occurs,
(1) Press the POWER button to turn off.
(2) Flip the switch at the
bottom to the
OFF/CHARGE posi-
tion.
(3) Replace with a fully
charged battery or
connect to the AC
adapter.
(4) Flip the switch at the bottom to the
ON position.
(5) Press the POWER button and
continue treatment.
To start the unit,
IMPORTANT! Your unit has two 'POWER'
switches. One on the
front of the unit, Fig. 8 ,
and the other on the
bottom, Fig. 9 .
1. Place the unit on a
solid, flat dry surface
making sure that the
water reservoir and
medicine cup have
been properly filled and the mouth nozzle
or other attachments are properly connect-
ed to the cover.
2. Flip the switch at the bottom to the "ON'
position. The LED indicator on the front of
the unit will illuminate.
3. Press the 'POWER' button.
Fig. 6
Fig. 7
POWER
AIR FLOW
Fig. 8
Fig. 9
To adjust the airflow, and nebulizer
rate,
1. Your Ultrasonic Nebulizer has 3 airflow
settings: High, Medium and Low.
High
Medium
Low
POWER
AIR FLOW
Fig. 10
To begin a treatment,
1. Follow the instructions provided by your
physician and/or respiratory therapist.
2. Your Nebulizer is designed to start at a
lower atomization rate in the beginning and
will become stronger after a few minutes.
NOTE: Although many medications are deliv-
ered within six minutes, thicker medications
will take longer to nebulize. The viscosity of
the medication and airflow setting may result
in longer treatment times and reduced battery
life between recharges.
Remember:
• Keep your eyes away from the output of
medication mist.
• If any discomfort or abnormality occurs,
stop using the unit immediately.
• Do not tilt or shake the unit when in
operation.
• Opening the cover during operation may
cause a severe injury.
To end a treatment,
1. When the treatment has ended, press the
POWER button. Postion the switch at the
bottom to the OFF/CHARAGE position.
Otherwise, your unit will automatically shut
off after approximately 10 minutes of
non-use.
2. Unplug the adapter from the outlet and
detach the adapter plug from the unit's
AC port.
3. Dispose excess medication and water
before disconnecting the battery.
4. Allow the unit to cool — approximately
20-30 minutes.
Remember:
• The unit should not be used for more than
30 minutes at a time.
• Wait 30 minutes before reusing the unit.
6
2. Based on instructions
from your physician
and/or respiratory
therapist, press the
airflow button to adjust
the airflow volume. The
Airflow Volume Indicator
Lights will show the
level (high, medium or
low) selected, Fig. 10.
Advertisement
Table of Contents
