Table of Contents
Advertisement
DISMANTLING INSTRUCTIONS
Opening of the Universal Loader Tray manually & Dismantling of the Cover Tray
1) Loosen 6 screws and remove the Cover Top (pos 255) by
sliding it out towards the rear before lifting up.
-
4 screws on the rear
-
1 screw each on the left & right side
2) Loosen 2 screws each to remove the Panel Left (pos 253)
and Panel Right (pos 254). The Panels are remove by
sliding it towards the rear and outwards.
-
1 screw on the side
-
1 screw on the rear
Figure 1
5) With the marking just outside the hole on the Cabinet Front
(pos 101) as shown in Figure 3, you have to feel and give
a push to unlock the tray of the Universal Loader before
sliding it out.
Figure 3
2-1
3) Take a paper clip or any stiff wire diameter of 1mm-1.5mm
and make a marking about 40mm from the tip as shown in
Figure 1.
4) Place the set in the position as shown in Figure 2 and insert
the paper clip or stiff wire into the hole on the Left side of
the Cabinet Front (pos 101).
6) With the tray of the Universal Loader opened, remove the
Cover Tray (pos 158) as shown in Figure 4.
Figure 2
Figure 4
Advertisement
Table of Contents
