Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Sunstar Machinery DPK-2
Summary of Contents for Sunstar Machinery DPK-2
- Page 1 USER MANUAL DPK-2 DPK-3...
- Page 2 During the first two weeks of machine operation, run the machine at 2,200 r.p.m for DPK-2, and at 2,000 r.p.m for DPK-3 machines. Afterwards, operate at a continuous rated 2,500 r.p.m for DPK-2, and at 2,300 r.p.m for DPK-3. Keep in mind that in actual operation of the machine, the speed must be adjusted in line with the operation method and the user's control over the machine.
- Page 3 The threads used for sewing should be able to move freely in the needle hole. Roughly or inconsistently woven threads normally break during sewing, and/or cannot give you the number of stitches you desire to get. The recommended thread for DPK-2 and DPK- 3 is cotton 80/3.
- Page 4 THREADING Your sewing machine comes with properly placed threads. Therefore, the easiest and simplest way to re-threading is to tie the thread that comes with the machine, with a new one. Check if the knotted area of the old and new threads goes through the needle hole smoothly. CAUTION Pull the thread 100mm out from the needle hole when starting the sewing.
- Page 5 HOW TO ADJUST THE WIDTH OF STITCHES You can adjust the width of stitches by turning the dial (A, Figure 8) in the center of the machine arm. If the dial is set at 0, the machine will perform straight line stitching. Turn the dial to the left to increase the width and to commence zigzag sewing.
- Page 6 FABRIC GUIDE The fabric guide comes supplied with the machine and is designed to align the edge of the sewing material with the seam lines. Refer to Figure 14 for installation. Unfasten the index screw (A, Figure 14) to adjust the fabric guide.
- Page 7 TABLE DRAWING - 7 -...
Need help?
Do you have a question about the DPK-2 and is the answer not in the manual?
Questions and answers