Recalling Measurements In Memory; Description Of Display Symbols; Troubleshooting - MABIS 04-391-001 Instruction Manual

Recalling Measurements in Memory

Recalling Measurements in Memory
You can recall up to 60 total measurements in memory. These meas-
urements can be shared with your physician or trained healthcare pro-
fessional.
1. Press and release the MEMORY button. It will show how many
measurements are stored within the bank, followed by the last
result, Fig. 1 .
2. Press the MEMORY button again to scroll through the saved
measurements. After youʼve scrolled through all the readings, the
unit will automatically turn off.
NOTE: When the number of readings exceeds 60, the oldest data will
be replaced with the new record.
To erase all stored measurements:
1. Press and release the MEMORY button. The unit will display how
many measurements are stored within the bank.
2. Press and hold down the MEMORY button until two horizontal lines
flash. This indicates that all measurements have been erased, Fig. 2 .

Description of Display Symbols

Fig. 1
Fig. 2
– 14 –
Description of Display Symbols
Indicates a measurement
SYS
DIA
Indicates a measurement
SYS
within Stage 2 Hypertension.
DIA
Indicates a measurement
SYS
DIA
Appears when batteries should be
replaced.

Troubleshooting

If any abnormalty occurs during use, please check and correct the following:
Condition
Display is blank when power is on.
Measurement incomplete or
abnormally low or high values
displayed.
EE symbol displays.
Measurements are different from
Shows the pulse rate per minute.
Occurs when an error was made
during measurement.
Appears when there is an irregular
heartbeat detected during
measurement.
Appears when the cuff is unstable or it
has too much air left in it. Once the
arrow stops flashing, the unit is ready
to take a measurement.
Appears when the unit is ready or a
measurement error has occurred.
Restart the measurement if an error
occurs.
Appears when recalling a
measurement from memory.
Correction
Check and correct the polarity of the
installed batteries. Reinstall or replace
batteries.
Review and follow "Applying Your
Blood Pressure Cuff" and "Taking
Your Blood Pressure Reading" sections.
Replace the batteries.
Do not talk or move during the
measurement. Review "Applying Your
Blood Pressure Cuff" section.
Remember, blood pressure readings
– 15 –