Advertisement
Assembly
Instructions
6
1. Release locking latch.
Unfold the stroller. Make
sure both sides of the
frame lock into place.
Remove foam packing
tubes from rear axle/
brake.
!
wARnInG: fROnt wheel COUld COMe Off And InjURy
COUld ReSUlt If SAfety pInS ARe nOt ASSeMBled pROpeRly.
3. Remove foam pack-
ing tubes from rear leg
tubes on the frame. At-
tach rear axle assembly
onto rear leg tubes by
inserting the left side a
little bit and then insert-
ing the right hand side.
Press both of them
together until the spring
loaded buttons click into
place.
ASSEMBLY INSTRUCTION
2. Lean the stroller backwards with the
front forks pointing up. Assemble the front
wheel as shown. Make sure safety pins
are placed in matching holes in frame on
both sides of the yoke. Tighten the lever on
the axle until it is very close to contacting
the fork then close the lever.
4. Remove plastic
packing tubes from the
rear wheel axle. Slide
wheel onto axle and
push until you hear a
click. Make sure it is
properly secure. Push
down on spring Clip if
necessary.
Safety pins
are on both
sides of the
wheel.
Advertisement
