Table of Contents
Advertisement
OSD Menu Functions
Management Settings
|---2---
The unit allows for remote control (adjust brightness for example) and/or accessing internal
information about the unit such as typenumber, serial number and more. To setup this feature, you
first need to configure the Serial or Ethernet protocol properly to match your external equipment
specifications. The contents of the submenus is listed below.
Settings as follows:
"RS232"
"2-wire RS-485"
"4-wire RS485/422"
"Address RS"
"IP Address"
"Download"
● Note: Default mode is "RS232" protocol.
A more detailed description of the SCOM (Serial/Ethernet Communication) can be found here:
http://www.hatteland-display.com/pdflink/inb100018-4.php
Review also the "Pinout Assignments" chapter in this manual for additional help during preperation
and/or installation of external equipment intended to communicate with.
User Controls
IND100064-38
- Communication
= Sets the internal communication to standard RS-232 protocol.
= Sets the internal communication to RS-485 protocol
(Half duplex).
= Sets the internal communication to RS-485/422 protocol
(Full duplex).
= Set the global unique channel/port ID for the unit, 16 ID's available.
= IP can be found Automatically or you can set the IP address
manually (xxx.xxx.xxx.xxx) for Ethernet protocol by choosing
"Fixed IP".
= Allows Factory Firmware upgrade for the unit via RS-232 Serial
Communication.
71
*Available in "Full Mode" only
Advertisement
Table of Contents
