Akkulift – Product description ® Many thanks for choosing our product Akkulift The drive is housed in a sealed hood, the control ® From now on, this sturdy, high-quality product will electronics in the sealed hand control. It is there-...
Akkulift in a perfect, hygienic con- ® dition. • Do not use any detergents containing acetic acid for cleaning the Akkulift ® ◗ Important information • The charging unit must only be used outside the bathroom in a dry environment. The charging •...
1. Backrest with drive and hand control unit remaining parts. The shipping carton should be kept for later use (i.e. transporting and storing 2. Collapsible frame with base plate incl. central Akkulift ® suction cup (black) 3. Backrest plate Prior to starting up the device for the first time we recommend to charge the storage battery.
➤ Please note: The suction cups at the underside of the Akkulift 4. Make sure that the lever for the central suction ® must be clean and dry, and the bath lift must cup (black) is in a raised position.
Page 8
Installation and use 5. Then insert the guide pins of the backrest into 6. Take the hand control in one hand and pull the bearing blocks of the frame, as shown. it away from the lift until the cable is slightly tensioned.
Page 9
Installation and use 8. Hold the backrest plate over the four fastening Due to the special arrangement of the fastening bolts and press it down to its end position. points for the backrest, the backrest cannot be placed-on incorrectly. 9. Insert the storage battery in the battery com- partment (figure).
Installation and use 10. Make sure that the lifting rod is in its correct position in the unlock ramp (see figures). ✓ wrong correct ◗ Attaching / removing covers The covers can be attached and removed very easily. • To fix the cover, place it correctly on the backrest pletely into the openings of the backrest plate / plate / seat and press the fastening buttons com- seat and side flaps (figure).
Installation and use ◗ Installation head rest (optional) Insert the two guide rods of the headrest into the two holes on the top of the backrest plate. The headrest can be stagelessly adjusted to the desired height. Seat Cover Seat Cover •...
Installation and use ◗ Hand control • Emergency stop-button (red): The capacity of a fully charged storage battery is If there is any situation in which it is necessary max. 20 baths, depending on the user’s weight. to stop all functions of the bath lift, press the red During these baths the green control lamp of the emergency button.
Installation and use ◗ Operating the Akkulift in the bath ® 1. Before starting up your Akkulift , make sure ® that the battery is inserted in the battery com- partment and the hand control is correctly con- nected (plug-type connection – see figure).
7. After bathing, press the orange key (“UP”-but- ton) of the hand control in order to raise the lift back to a convenient height (the max. position Using the hand control, first lower Akkulift to its ® is the upper stop position).
Page 15
Installation and use 3. Make sure that the lifting rod is retracted (figures). ✓ wrong correct 4. The backrest can now be removed from the frame in the direction of the arrow shown. ➤ Note: The backrest cannot be removed from the frame when it is completely folded down to the seat, because the backrest is then in a locked position again! Lift the...
Maintenance and care ◗ ◗ Maintenance of the Akkulift Assembly of new cover plugs ® for cover of Akkulift ® Akkulift is equipped with bearings and running ® surfaces which are completely maintenance-free Guide the new plug through the opening of the and do not require any lubrication.
Maintenance and care ◗ Maintenance of the charging unit The charging unit does not require any mainte- nance. The housing must only be cleaned with mild detergents, which are free from solvents, or by means of a damp cloth. Make sure that no li- quid penetrates the charging unit.
1. Take the storage battery out of the battery compartment and store it separately. 2. Secure the lift against sliding or slipping during transportation. 3. If Akkulift was exposed to low temperatures ® (e.g. storage in a vehicle during the winter), allow it to warm up to room temperature before use and recharge it, if necessary.
• Contacts are contaminated – Clean contacts with a dry cloth ➤ Important remark for troubleshooting: Should it not be possible to operate Akkulift despite observing all of the above-mentioned information, ® please contact the dealer who sold you the device.
Supplement ◗ ◗ Disposal Warranty At the end of the product life, all components of Our warranty for Akkulift will be in accordance ® the Akkulift and storage battery should be dispo- with legal stipulations and/or regulations valid in ®...
Supplement ◗ Spare parts and accessories for Akkulift ® The correct order numbers of original spare parts and accessories are given in the table below. Article Order number • Seat and backrest covers Cover Set Comfort, white 410100252 Cover Set Comfort, blue...
Please read the operating instructions! maintenance, repair and guarantee claims: (WW/YY) Indicates the year and week of production of Akkulift ® Indicates the serial number of Akkulift ® ◗...
Emergency-stop..........5 Safety............5 Side flaps.......... 10, 13, 14 End postion, down........13 ..23 End position, up........... 13 Spare Parts and accessories for Akkulift ® ......6, 13 Error............21 Starting up your Akkulift ® Storage............18 Explanation of symbols.........
Need help?
Do you have a question about the Akkulift and is the answer not in the manual?
Questions and answers