Table of Contents
Advertisement
A
ssembly
1. Connect hose to vacuum by inserting
hose connector on the end of the hose
into the suction inlet. make sure the hose
is positioned so the tabs on the hose
connector line up with the notches on the
suction inlet. once inserted into the
suction inlet, turn counter clockwise to
lock into place.
2. Attach extension wands section together
by inserting into one another and
twisting slightly to tighten.
3. Connect hose handle to the end of the
extention wand and twist slightly to
tighten.
4. Connect floor nozzle to the end of the
extension wand and twist slightly to
tighten.
5. once assembled, you can store your
vacuum by inserting the storage clip
(located on the back of the floor nozzle)
into the storage slot on the rear of the
vacuum.
0
perations
Power cord
the power cord is located at the rear
of the vacuum. gently pull out the
power cord, watching for the yellow
line. stop pulling the power cord once
the yellow line is visible. there is also
a red line, which indicates the end of
the usable cord. do not pull the
power cord out beyond the red line.
automatic cord rewind
your vacuum is equipped with an
automatic cord rewind. When
cleaning is finished, press the power
button off and grasp the plug to
disconnect from the electrical outlet.
Hold the plug and press the automatic
cord rewind button to rewind the cord
automatically.
Power button
turn the power on or off by pressing
lightly downward on the power button
(
).
w w w . b i s s e l l . c o m
WaRning:
Plastic film can be dangerous. To
avoid danger of suffocation, keep
away from babies and children.
suction Inlet
1.
3.
5.
caution:
Be careful to avoid injury as cord
retracts very quickly.
caution:
Before using your vacuum,
make sure that the dirt cup and
all filters are in place. Do not
operate your vacuum without
the dirt cup and filters.
Power Button
2.
4.
Automatic Cord
Rewind Button
5
Advertisement
Table of Contents
