Page 1
Pool Heater Installation Information Water Piping Connections Chemical Use Electrical Startup Procedures Preventive Maintenance Troubleshooting IM1009PN 04/13...
58,000 1500 109,000 80,000 1750 119,000 83,000 04/19/13 Note: All Envision Series Pool Heaters are safety listed under UL1995 through ETL, and performance tested in an accredited ISO 17025 laboratory in accordance with, but not certified under AHRI standard 1160.
ENVISION POOL HEATER INSTALLATION MANUAL General Information Safety Considerations General Information • Qualified personnel should perform installation, You now own one of the most efficient and versatile pool maintenance, and service. heaters on the market today. Your heat pump pool heater •...
ENVISION POOL HEATER INSTALLATION MANUAL Dimensional Data Water Model Connections 2˝ ID 0750 32.9 24.5 38.0 26.0 PVC UNION 2˝ ID 1100-1750 32.9 32.5 38.0 34.0 PVC UNION 04/11/13 NOTE: All dimensions are in inches. Physical Data Model 0750 1100...
ENVISION POOL HEATER INSTALLATION MANUAL Water Flow and Connections Water connections are made at the rear of the heater. Typical Installation Both water in and out are labeled just above the water Heat Pump connections. LEFT REAR = WATER OUT and RIGHT REAR Pool Heater = WATER IN.
ENVISION POOL HEATER INSTALLATION MANUAL Electrical Connections Field connections must comply with national and local Wiring Main Power Supply codes. The work must be done by a qualified electrician. 1. Remove the screws from the plastic front panel, located on the control display side of the unit.
ENVISION POOL HEATER INSTALLATION MANUAL Electronic Control Panel Selecting Pool or Spa Mode Control Settings Press the POOL/SPA/STANDBY button until you reach the Temperature Setpoint desired mode. The LED indicator light will verify the mode • Temperature setpoint maximum for POOL mode is 95°F that has been selected.
ENVISION POOL HEATER INSTALLATION MANUAL Startup Procedures Before proceeding with this section make certain all Defrost Cycle plumbing connections are airtight and leak-free. The heat pump pool heater has automatic defrost. When the outdoor temperature drops below 40°F, frost may Flow rates should not exceed 70 gpm maximum.
ENVISION POOL HEATER INSTALLATION MANUAL Preventive Maintenance WARNING: Disconnect electrical power to unit before Winterizing starting any maintenance to prevent serious injury When the heater is exposed to freezing temperatures, it is from shock. essential that all water within the unit be properly drained.
Page 13
ENVISION POOL HEATER INSTALLATION MANUAL Notes...
ENVISION POOL HEATER INSTALLATION MANUAL Warranty Registration This warranty registration form must be fi lled out in full and mailed or faxed to WaterFurnace International within sixty (60) days from the date of installation. Do not mail the warranty certifi cate.