Sanyo LED-24XR113D Service Manual page 50

If the stand is provided, please read these instructions thoroughly before attempting this installation.
You must install your TV into the stand in order for it to stand upright on a cabinet or other flat surface. If you intend to mount your TV
on a wall or other vertical surface, you must remove the stand column.
Cautions:
Make sure that you handle your TV very carefully when attempting assembly or removal of the stand. If you are not sure of
your ability to do this, or of your ability to use the tools necessary to complete this job, refer to a professional installer or
service personnel. The manufacturer is not responsible for any damages or injuries that occur due to mishandling or
improper assembly.
When using a table or bench as an aid to assembly, make sure that you put down a soft cushion or covering to prevent
accidental scratching or damage to your TV's finish.
The speaker is not intended to support the weight of your TV. Do not move or handle your TV by the speaker. This can
cause damage to your TV that is not covered by the manufacturer's warranty.
Before attempting assembly or removal of the stand, unplug the AC power cord.
To install the stand:
1. Carefully place your TV screen face-down on a cushioned, clean surface to protect the screen
from damages and scratches.
2. Align the locators on the stand column with the locating grooves on the back of the TV and secure
the stand column to your TV with the three screws provided.
3. Make sure the wide portion of the stand base faces the front of your TV. Align the base with the
stand column, then secure the base to the column with the screw provided.
Locating grooves
To remove the stand from the TV, perform these steps in reverse order.
NOTE:
The appearance of this product in these illustrations may differ from your actual product, and is for comparative
purposes only.
Appendix: Installing the Stand
Stand column
Stand base
Stand column