Troubleshooting - DèLonghi Dragon 4 Instructions For Use Manual

Reminder
To completely shut the appliance off, turn the power selector to
the "0" position and then unplug the appliance from the outlet.
UNITS WITH TIMER
How to use the timer
To program heating, proceed as follows:
- Look at the time on your clock or watch. If it is 10 p.m., turn
the numbered timer disk clockwise until the number 22 (10
p.m.) on the disk coincides with the pointer s (3) on the
timer. Set the periods of time when you want the appliance
to work by pushing the teeth (1) inward. Each tooth (1)
corresponds to a period of 15 minutes. This will leave
visible sectors which correspond to the periods of operation
(2). When set, the radiator will operate automatically each
day during the times programmed (important: the radiator
must always be plugged into the socket).
- To change the programming, move the teeth back into the
initial position and set the new periods of operation.
- To turn the appliance off completely, as well as turning the
knob to the off position, you must also unplug it from the
power outlet to avoid continued operation of the timer.
IMPORTANT: DO NOT ROTATE CLOCK DIAL COUNTER-
CLOCKWISE.

TROUBLESHOOTING

PROBLEM
The appliance doesn't work
The timer is like an electric clock, and will only work when
plugged into a power supply. When unplugged, the timer stops
and must be later re-set.
Timer override
If you wish to override the timer settings, push the timer switch
to position I (fig.2) manual (timer override). To return to timed
operation push the switch back to the middle position
(fig.2).
NOTE: if the timer switch is at the 0 position (fig. 2), the
heater is off and will not operate).
Safety device
A safety device shuts the radiator down in the case of
overheating. To start the radiator up again, contact Customer
Experience. See enclosed guarantee leaflet.
MAINTENANCE AND SERVICE
Always unplug the heater from the power outlet and allow the
radiator to cool. Wipe radiator with a soft damp cloth; do not
use detergents or abrasives. Should the radiator not be in use
over a certain length of time, wind the cord around the holder
and store it in a dry place. This appliance has been built to last
for many years of trouble-free service. In case of malfunction
or doubt, do not try to repair the heater by yourself: this might
increase the risk of fire and electric shock. Please refer to the
enclosed guarantee leaflet for service and assistance details.
CAUSE
Be sure it is plugged in and that the
electrical outlet is working.
Check for any obstruction.
The temperature may be set too low.
5
Heater off
Timer operation
Manual (timer override)
SOLUTION
Plug into the power outlet.
Remove the obstruction and let the
appliance cool down. If the appliance
doesn't work please contact Customer
Experience.
Set the temperature to a higher position.
Fig. 2