Table of Contents
Advertisement
2.1 Mounting the Image Converter:
The following steps explain how to attach the PRO35 properly to your camera:
Instruction
1
Make sure that the quick-lock plate holder for the
15 mm lightweight support is assembled to the
bottom of the camera as shown in the photo.
2
Assemble the support bridge delivered with the
PRO35 on the quick-lock plate, as shown in the
photo.
3
Assemble the PRO35.
3.1 Attach the post to the bottom of the PRO35
unit.
3.2 Lower the support for easier installation (lever
shown as Screw A in photo).
3.3 Loosen two screws on either side of Screw B in
photo. Like this the bridge can be adjusted if ne-
cessary. For adjusting the bridge loosen screws
on the bottom.
3.4 Install the PRO35 Image Converter on the came-
ra and lock the clamp ring of the B4 Mount.
3.5 Raise Screw A until post bears on precisely.
3.6 Engage and tighten the knob B in the bottom of
the post. Also tighten the two screws placed eit-
her side of Screw B.
Explanatory Notes
E
2
15
Advertisement
Table of Contents
