Inspecting Burners - Desa VRL24NR Owner's Operation And Installation Manual

OPERATING HEATER
Continued
Indicator
Light
Locks
ROOM
TEMP
System to
Prevent
LOCK
Accidental
Ignition
MANU
Turns
Burners
On or Off
Increases or
Decreases Room
Temperature in
AUTO Mode
Figure 35 - Thermostat Hand-Held
Remote Control Unit (HRC200)
Manual Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press the MANU button to turn on the
fireplace.
3. Press the POWER and LOCK buttons
together to turn off the fireplace.
Auto (Thermostatic) Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by press-
ing the TEMP + or - buttons.
4. Press the POWER and LOCK buttons
together to turn off the fireplace.
Note: Do not leave the hand-held remote in the
AUTO mode close to the fireplace. The radiant
heat from the fireplace will turn off the fireplace.
Ideally, place the hand-held remote in the center
of the room facing towards the fireplace.
Note: Do not hold the hand-held remote for
a long time. Body temperature will affect its
operation in the AUTO mode.
Safety Features
When away from home for an extended period
of time or as a child safety feature to prevent
accidental ignition of the fireplace, the receiver
ON/OFF/REMOTE switch should be in the
OFF position.
110021-01N
Digital
Display
Shows
AUTO
Temperature
SET
TEMP
and Settings
TEMP Turns Hand-
POWER
Held Remote
On or Off and
AUTO
ºC/ºF
Allows You
to Choose
the Manual
Setting
Selects AUTO
Mode
°C/°F Mode
Button
www.desatech.com
Auto Shutoff Feature
1. If the average room temperature exceeds 82
degrees Fahrenheit (28 degrees Centigrade),
the hand-held remote control will perform a
safety override and shut the fireplace off. This
feature is not available in the MANU mode.
2. The receiver continuously receives signals
from the hand-held remote to control the
room temperature. If the hand-held remote
is misplaced, obstructed or for any reason
cannot transmit to the receiver, the receiver
will shut off the fireplace after 8 minutes.
Key Pad Lock Feature
This feature allows the user to lock/unlock
the keypad on the hand-held remote in the
MANU or AUTO mode to prevent inadvertent
operation (i.e. children operating the hand-held
remote control, etc.). The keypad is locked in
either on or off. Press the POWER and LOCK
buttons together to turn the unit on or off.

INSPECTING BURNERS

Check pilot flame pattern and burner flame pat-
terns often.
PILOT FLAME PATTERN
Figure 36 shows a correct pilot flame pattern.
Figure 37 shows an incorrect pilot flame pat-
tern. The incorrect pilot flame is not touching the
thermocouple. This will cause the thermocouple to
cool. When the thermocouple cools, the heater will
shut down.
If pilot flame pattern is incorrect, as shown in
Figure 37
• turn heater off (see To Turn Off Gas to Ap-
pliance, page 21 [thermostatically-controlled
model] or page 24 [remote-ready models])
• see Troubleshooting, page 28
Note: The pilot flame on natural gas units will
have a slight curve, but flame should be blue and
have no yellow or orange color.
Pilot
Thermocouple
Burner
Figure 36 - Correct
Pilot Flame Pattern
(Natural Gas Pilot
Shown)
Thermocouple
Pilot
Burner
Figure 37 - Incorrect
Pilot Flame Pattern
(Natural Gas Pilot
Shown)
25