Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Vermeiren Shark
- Page 1 VERMEIREN operator control Shark I N S T R U C T I O N M A N U A L...
- Page 3 (see the "Error codes" section). Vermeiren is responsible for the changes in the software. For changes in the software contact Vermeiren. The Shark system is available in three different operator controls which have some different operating buttons. Operator control type 1...
- Page 4 Shark Operator control vA - 2011-07 Press the "ON/OFF" button (1). The charge indicator (2), which also indicates the batteries' charge level, lights up for a moment. If all the lights come on, the batteries are sufficiently charged. If the lights do not all come on, you must adjust your driving activities to suit the low capacity of the batteries.
- Page 5 Press the Horn button twice before the countdown is completed (approximately 10 seconds). The current state-of-charge will then be displayed and SHARK may be operated normally. If the user does not press the Horn button twice before the countdown is complete, the Horn will sound a short beep and your operator control will turn itself off.
-
Page 6: Adjusting The Driving Speed
LED’s will fill in until maximum speed (as displayed) is reached. If the bottom, left-most GREEN LED is flashing SHARK is in SPEED LIMIT mode, which limits the drive speed to a pre-programmed value, typically when a seat is raised or tilted and driving too... -
Page 7: Attendant Control
Shark Operator control vA - 2011-07 1.6. Attendant Control When the attendant control is activated, the ACU LED will light up and remain light until the attendant relinquishes control. 1.7. Using the horn Press the horn button. The horn shall sound as long as the button is pressed. -
Page 8: Using The Joystick
Shark Operator control vA - 2011-07 1.10. Using the Seat Function Button (only for type 3 operator control) Two seat functions are available for individual adjustment and are accessed via the Seat Function Button. Press the Seat button once to toggle the control unit from Drive mode to Seat mode. -
Page 9: Error Codes
Right parking brake (or its As described above. connection) is defective Shark control is defective Unplug both motors. Switch the steering off and then on again, while leaving the joystick in the neutral position. If this flashing sequence appears again, the steering is defective. - Page 10 Notes ........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................
- Page 12 Fax: +41(0)31 818 40 98 website: www.reatime.it website: www.vermeiren.ch e-mail: info@reatime.it e-mail: info@vermeiren.ch Poland The Netherlands Vermeiren Polska Sp. z o.o Vermeiren Nederland B.V. Domstraat 50 Łączna PL-55-100 Trzebnica NL-3864 PR Nijkerkerveen Tel: +48(0)71 387 42 00 Tel: +31(0)33 2536424...