Digital Clock; Battery Operation - Telefunken TF-?SRP3480 Instruction Manual

Utilization of the product
If you want to dispose of this product, do not
mix it with general household waste. There is a
separate collection system for used electronic
products in accordance with legislation that
requires proper treatment, recovery and
recycling.
Please contact your local authorities for
the correct method of disposal. By doing so,
you will ensure that your disposed product
undergoes the necessary treatment, recovery
and recycling and thus prevent potential
negative effects on the environment and
human health.
Important safeguards
• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer to the
manual. Keep the manual for future use.
• Do not hit or drop the unit.
• Do not expose the unit to vibration, direct
sunlight, too high or low temperatures or
humidity.
• Do not disassemble the unit yourselves.
Refer servicing to qualified service personnel
All the illustrations in this manual are
schematic images, which may differ from
actual objects.
Power supply

Battery operation

• Open the battery compartment cover.
• Insert 6 x UM-2/LR14 batteries. Please
observe correct battery polarities or the set will
not work.
• Close the battery compartment cover.
This unit has a battery saver function.
Instruction manual
If you wish to preserve the batter life use the
switch (#20). The unit will not use the battery
power which will enhance battery life. Please
note that in this mode time settings and radio
presets will be lost.
AC operation
• Before the first connecting of the appliance
check that voltage indicated on the rating label
corresponds the mains voltage in your home.
• Plug the corresponding end of cord into
the AC socket on the rear of the set.
• Insert the plug into power supply.
Caution:
• When the set is only used with AC or is
not used for 2 weeks or more, please remove
the batteries, to avoid damage to the set from
leakage of batteries.
• Always switch off the unit when not in use.
• Always unplug the appliance from power
supply, when not using the device for a long
time.
General operations

Digital clock

This unit has a built-in digital clock which is
displayed when the set is in the standy mode.
• Switch the unit to standby mode.
• Press and hold CLOCK SET, the display
will show blinking 12 or 24 hour indications.
• Press TUNE+/- to choose and press
CLOCK SET to confirm your selection.
• Press TUNE+/- repeatedly to set correct
hour, confirm by pressing CLOCK SET. Follow
the same procedure for minute setting.
Electronic volume control
• This unit uses an electronic volume control.
To increase or decrease the loudness of unit,
press respectively VOLUME UP/VOLUME
DOWN buttons.
3