Related Manuals for WarbirdKits IAR-80
Summary of Contents for WarbirdKits IAR-80
- Page 1 Industria Aeronautica Româna IAR-80 Romania’s Indigenous WWII Fighter Version 1.3 Scale: 1/12 Wingspan: 34 in Area: 146 sq in Length: 29 in Weight: 17-19 oz Power: Speed-400 Copyright 2012 Thomas A. Jacoby and WarbirdKits.com...
- Page 2 Assembly Manual for IAR-80 (Version 1.3) Miscellaneous servo mounting materials and pushrods Materials Covering materials and paint This kit contains the following materials: Glue This manual 6-Volt Speed-400 power system or equivalent size Plan sheet brushless inrunner Laser-cut wood pack...
- Page 3 Assembly Manual for IAR-80 (Version 1.3) with another board, books or what have you. Keep the Glue the aileron leading edge to the bottom sheet, weight on the skin until it is completely dry. about 1/32” aft of the aileron spar. DO NOT glue the aileron leading edge to the aileron spar.
- Page 4 Assembly Manual for IAR-80 (Version 1.3) Cut a hole in the top skin for the aileron crank. Install the 1/8” dowel in the leading edge. The dowel should project about 1/4” forward of the wing. Apply a thin bead of Pro-Bond or aliphatic resin to the...
- Page 5 Assembly Manual for IAR-80 (Version 1.3) Glue the two F4L BRACE parts in place on the Fill the lower fuselage area between F10L and F11 rear of F4L. with scrap 1/4 balsa. Use a sharp blade to score F4L along the Cut the planking and keels to remove the section of broken line.
- Page 6 Assembly Manual for IAR-80 (Version 1.3) Glue short 1/8 locating dowels in the two holes you just Glue the cowling nose to the cowling. drilled. These dowels should protrude forward from Set former F0 in place on the fuselage. former F1 about 1/8 to 1/4 inch.
- Page 7 Assembly Manual for IAR-80 (Version 1.3) Apply a light coat of primer – just enough to fill the weave of the glass – and sand most of it off. Paint and decorate the model as desired – see the Paint and Markings Guide on our Website for more information.