Sanyo VPC-AZ1EX Service Manual page 17

2. Double-click on the DscCalDi128.
3. Click the AWB, and click the Yes.
4. AWB adjustment value will appear on the screen.
5. Click the OK.
4. Color Adjustment
Camera
Preparation:
POWER switch: ON
Adjustment method:
1. Set the color adjustment chart to the color viewer.
(Do not enter any light.)
2. Set the color adjustment chart so that it becomes center
of the screen.
3. Double-click on the DscCalDi128.
4. Click the "UV Matrix", and Click the "Yes".
5. Adjustment values will appear on the screen.
6. Click the OK.
5. CCD White Point Defect Detect Adjustment
Preparation:
POWER switch: ON
Adjustment method:
1. Double-click on the DscCalDi128.
2. Select "CCD Defect" on the LCD "Test", and click the "Yes".
3. After the adjustment is completed, the number of defect
will appear.
All white pattern color
viewer and color matrix
adjustment chart
– 17 –
6. CCD Black Point Defect Detect Adjustment
Camera
Preparation:
POWER switch: ON
Adjusting method:
1. When setting the camera in place, set it to an angle so
that nothing appears in any part of the color viewer ex-
cept the white section. (Do not enter any light.)
2. Double-click on the DscCalDi128.
3. Select "CCD Black" on the LCD "Test", and click the "Yes".
4. After the adjustment is completed, the number of defect
will appear.
7. LCD Panel Adjustment
[CA3 board (Side A)]
CL578
7-1. LCD H AFC Adjustment
Preparation:
POWER switch: ON
Adjusting method:
1. Double-click on the DscCalDi128.
2. Select 0 on the LCD "H AFC".
3. Apply a trigger using CL407, and adjust LCD "H AFC" so
that the time A from the rising signal at CL407 to the fall-
ing signal at CL404 is 5.26 ± 0.2 µsec.
All white pattern
Color viewer
VR513
CL407
(CSYNC)
CL402(G)
CL404
(XENB)
CL401(B)
CL403(R)