Advertisement
FIGURE 22
Fully Assembled Evening Crossfire Log Set shown with Optional Manual V17 Valve.
STEP SEVEN: LIGHTING AND OPERATION INSTRUCTIONS
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.
Applies to Natural Gas Models F, FH, FX, FXH. All other models refer to supplied instructions.
BEFORE LIGHTING: Smell around the burner area and next to floor for gas. Propane gas is heavier than air and may
settle on the floor. If you smell gas follow the instructions on page 1.
STANDARD MATCH LIGHTING
•
1. Place lighted match on embers near inlet end of burner (Figure 23 ).
DO NOT HOLD MATCH IN HAND! Move away from front of fireplace.
2. Slowly open Fireplace Gas Supply Valve and wait for burner to light.
3. Adjust Fireplace Gas Supply Valve for desired flame height.
4. To shutdown close Fireplace Gas Supply Valve completely.
MATCH LIGHTING WITH OPTIONAL ACCESSORY V-17 VALVE
•
1. Ensure that the Manual V-17 Valve is completely closed.
2. Open Fireplace Gas Supply Valve.
3. Place lighted match on embers near inlet end of burner (Figure 23)
DO NOT HOLD MATCH IN HAND! Move away from front of fireplace.
4. Slowly open Manual V-17 Valve and wait for burner to light.
5. Adjust Fireplace Manual V-17 Valve for desired flame height.
6. To shutdown close both Manual V-17 Valve and Fireplace Gas Supply
Valve completely.
Cut away View
Showing Inlet Side of Burner
under Pan Medium and Ember Magic
14
FIGURE 20
Advertisement
