Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Warning
1.
Do not use in places where there is condensation or water build up.
2.
Direct connection of AC line must be carried out by a licensed and professional electrician.
3.
The power must be off for machine installation.
4.
Hand dryer must be installed indoors. A clean and unobstructed environment is required.
5.
The power is 220v-240v/50Hz AC.
6.
Unauthorized disassembling and reassembly is not permitted, it may lead to fire, electric shock,
product failure, voiding of warranty etc.
Attention
1.
The dryer should be installed at least 400mm from other appliances or fixtures. Do not install in
positions where bright light or highly reflective surfaces may interfere with the sensor operation.
2.
Product must be installed on strong flat wall to avoid possible dislodgment that may cause personal
injury or damage to the product.
3.
Do not install the product where it may come in contact with corrosive or flammable gases or
materials that may cause fire, product or operational failure.
4.
Do not install the product in or dusty environments, as it may cause product or operational failure.
Installation
Suggested Installation Height
From Floor to Top of Hand Dryer Approx.1300 mm From Floor to Bottom of Hand Dryer Approx. 850 mm
Complies with Disabled Persons Requirements
Electrical Installation Options
Simple electrical connection by plug and lead as supplied. Or can be direct wired by qualified electrician.
1. Unpack the product.
2. Locate the water collection tray and remove it. ( See Figure 1 )
By pressing the release latch on the bottom left of the unit.
3. Locate the air filter compartment and remove it. Locate the security screw inside and remove it to detach
the mounting plate from the unit. ( See Figure 2 & 3 )
4. Fix the metal mounting plate onto the wall, using the expanding screws and plugs supplied. Ensure plate
is mounted level. ( See Figure 4 )
5. Hang the dryer on the metal mounting plate.
6. Fix the machine securely by replacing the security screw. Replace the air filter and the water collection tray
to finish the installation.
1
2
3
4
Advertisement
Table of Contents
