Oven Door; Door; Door Re-Installation - Wolf DF30 Technical & Service Manual

Component Access & Removal
Oven Door Components
Oven Door Removal
The oven door uses a spring and damper system. Only
one hinge arm is spring loaded, which requires use of
the hinge pin for removal.
On 30-inch and 36-inch units, the hinge pin will be
inserted through the hole in right hinge arm (looking at
the front of the unit). (See Figure 4-32 and 4-33)
On 48-inch and 60-inch units, the spring hinges are
located on the outside edges of the unit. On these
units, the left oven door will have the spring hinge on
the left side. The right oven door will have the spring
hinge on the right side. (See Figure 4-33)
Door(s) Removal
To remove oven door, first open the door to its fully
opened position. Insert the hinge pin through hole in
the appropriate hinge arm. (See Figure 4-34) Remove
the screw and the retainer clip from the hinge cover.
NOTE: On units with a new style single hinge retainer
plate (See Figure 4-34A), it will require the removal of
skirt prior to door removal. The new style single retain-
er plate will remain with the door during removal once
the two screws, securing the retainer plate, are
removed.
Close the oven door to about a 60° angle from the hori-
zontal. Lift up on the door while continuing to pull the
door away from the unit.
For 48-inch and 60-inch units, complete this procedure
for both the left and right oven doors.
If the pin device is too long, it will rub against the
inner door liner and chip the porcelain.
DO NOT LIFT OR CARRY THE OVEN DOOR BY THE
DOOR HANDLES.
FAILURE TO INSERT SUPPLIED PIN IN APPROPRI-
ATE HINGE ARM WILL CAUSE DAMAGE TO UNIT,
AND POSSIBLE INJURIES MAY OCCUR.
Door(s) Reinstallation
To reinstall door assembly, fully extend hinge claw of
hydraulic damper hinge. Next, hold oven door on oppo-
site sides, lift door until the hinges are aligned with the
hinge openings in the oven frame. Now, insert hinge
claw of hydraulic damper hinge into hinge pocket before
inserting the spring side hinge.
D D u u a a l l F F u u e e l l R R a a n n g g e e
PLACE PIN ON
SPRING SIDE OF UNIT
Figure 4-32. Pin Placement for 30" and 36" Units
SPRING SIDE OF UNIT
Figure 4-33. Pin Placement for 48" and 60" Units
SCREW
Figure 4-34. Pin Placement On Hinge
4-16
PLACE PIN ON
PLATE
HINGE
PIN