Maintenance; Environmental Protection - Ryobi RDP102L Operator's Manual

FEEDING
1. Pull down the feed handles with only enough effort to
allow the drill bit to cut.
2. Feeding too slowly might cause the drill bit to burn.
Feeding too rapidly might cause the belt or drill to slip,
tear the workpiece loose or break the drill bit.
3. When drilling metal, it is necessary to lubricate the drill
bit tip with oil to prevent burning of the workpiece and
bit.

MAINTENANCE

For your own safety, turn the switch OFF and remove
the plug from the power source outlet before maintaining
or lubricating your drill press.
Frequently blow out, using an air compressor or dust
vacuum, any sawdust or metal chips that accumulate
inside the motor, pulley housing, table and work surface.
Always wear protective safety goggles.
To avoid shock or fire hazard, if the power cord is worn
or cut in any way, have it replaced immediately by a
qualified electrician or service technician.
LUBRICATION
All of the drill press ball bearings are packed with grease
at the factory. They require no further lubrication.
Periodically lubricate the gear and rack, table elevation
mechanism of the spindle the rack (teeth) of the quill.
Lower the spindle down and oil the spindle sleeve
moderately every three months.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
SYMBOL
Safety alert
Regulatory
Product
requirements.
WARNING
WARNING
Compliance Mark
meets applicable regulatory
(RCM).
20
Please read the instructions carefully
before starting the product.
Laser radiation. Do not stare into beam.
Do not expose to rain or use in damp
locations.
Wear ear protection
Always wear eye protection
Chuck Capacity
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your Local Authority or retailer for recycling
advice.