Brinkmann Balance Manual

Manual for

Legal regulation of the European Community :

This turntable had been designed and testet according to the guidelines EN55013 and

EN55020, and it meets the safety requirements EN60065.

Informations for Safety :

The turntable BALANCE is only to be used in dry rooms with an average temperature

and is only allowed for 220-240V, 50...60Hz alternating current.

The power supply is only to be connected to grounded wall sockets.

Please connect or disconnect only when the mains plug is not connected to the mains.

Always disconnect the power supply from the mains when the turntable is not used for a

longer period of time ( during holidays etc. ) ! Never leave the power supply unattended

while it is connected to the mains !

Always keep the turntable away from wet, heat and open fire ! Never expose it to the

blazing sun ! Never place receptacles with fluids on the turntable or power supply !

Never open the casing while the power supply is connected to the mains !

Attention, dangerous voltage !

The power supply is equipped with a temperature limiter that switches off at about 65°C

; to guarantee a flawless function please make sure to have a free space for air

circulation measuring 30cm above the power supply and 10cm on each side. The

heatsinks are never to be covered !

After disconnecting from the mains, the turntable can be cleaned with a dry cloth or a

brush, do not use wet cleaning, wet cleaning can cause damages !

brinkmann

design + service

Brinkmann Audio GmbH

Im Himmelreich 13

88147 Achberg

Tel.:08380/981195

Fax:08380/981233

www.brinkmann-audio.com

info@brinkmann-audio.com

Table of Contents

Do you have a question about the Balance and is the answer not in the manual?

Page 1 EN55020, and it meets the safety requirements EN60065. Informations for Safety : The turntable BALANCE is only to be used in dry rooms with an average temperature and is only allowed for 220-240V, 50...60Hz alternating current. The power supply is only to be connected to grounded wall sockets.
Page 2 Repairs, modifications etc. are only to be carried brinkmann out by the company itself or by specially authorized workshops ! The glass cover of the platter can be cleaned with multipurpose screen and surface wipes and a dry cotton cloth.
Page 3 Here the platter must be lowered exactly vertical to place it without getting stuck. Possibly the ground plate will get out of horizontal balance by the weight of the platter, please control the balance on the platter surface again.
Page 4 (please read the part Informations for safety). Never use solvent ! We strongly recommend to use a record cleaning machine for best results. The BALANCE turntable will be delivered with following components : Chassis (plinth) + screwdriver No. 6 for tonearmbase, + screwdriver No.