Omnii ST4000 Quick Start Manual

Contents of the Box:
One of the following Snap Modules:
ST4000 (Charger)
ST4001 (USB Host/Client) Om nii
Snap Module
s Quick Start
Guide
ISO 9001 Certified
Quality Managem ent System
ST4005 (DE9M Serial)
This Guide
Optional Accessories:
PX3058 USB Micro-B to Type A cable
ST1050 AC Wall Adaptor and plugs ST3113 Vehicle Power Outlet Adaptor
(12VDC, 2.5 A)
Features: Operation
The Snap Module is a mobile adaptor for Omnii and is compatible with the AC Wall
Adaptor and the Vehicle Power Outlet Adaptor.
The following types of Snap Modules are available:
Model No. ST4000 (Charger only variant): powers and charges the hand-held.
Model No. ST4001 (USB Host/Client variant): powers and charges the hand-held. It
provides communications via USB 1.1/2.0 Host and USB 2.0 Client connectors and
provides a DC IN port. When attached to Omnii it allows ActiveSync or Windows Mobile
Device Center connectivity with your PC, connection to an AC wall adaptor (Model No.
ST1050) or a Vehicle Power Outlet Adaptor (Model No. ST3113), and the use of a USB
device such as a USB memory key or supported peripheral.
Model No. ST4005 (DE9M Serial variant): provides a powered DE9M serial connector.
It powers and charges Omnii, and provides serial communications to tethered devices.
The DE9M connector is capable of speeds up to 115,200 bps. Pin 9 is reserved for 5V
power out and is defaulted to off. To enable power to this port, in your Omnii desktop,
go to Control Panel>Teklogix Scanners, which opens the Scanner Settings menus. In
the Ports menu, select on for the Power parameter under the COM6 port.
Features: Back of Snap Modules
DC IN Jack (12V, 2.5 A)
Bottom Ports
ST4000
None
ST4001
Type A (Host) USB port (5 VDC, 500 mA max)
Micro-B port (for ActiveSync © or
Windows Mobile Device Center)
ST4005
Powered DE9M Serial port
(9 pin, 5VDC, 1A max)
Getting Started
1 Preparing the Equipment.
Make sure that the adaptor connector and Omnii docking connector
are free of dust or any other debris before connecting them.
2
Attaching the Snap Module to Omnii.
.
A slot in the side rail on each side of Omnii accommodates the locking clips
of the Snap Module. To attach the adaptor, align it with the Omnii base and
gently slide up until the locking clips snap into place.
Note: If you are using a hand or shoulder strap, there is no need to remove it before
installing the Snap Module, since the Omnii hand strap slot will still be accessible.
Side Rail
DC IN Port
Locking Clip
Hand Strap Slot
3
Connect the Snap Module to a Power Source.
Connect the module to an AC or DC power source using the appropriate adaptor
cable. Then connect the adaptor's DC plug into the Snap Module's DC jack. You
can also attach an ST4001 or ST4005 Snap Module to the Omnii and use the Omnii
battery to power USB or serial peripherals, for enhanced mobility.
Over