Clock And Timer; Cd - Sylvania SKCR2713 Instruction Manual

Setting the Clock
1. With the power off, press and hold the Clk set/Mem button. The hour on the display will
begin flashing.
2. Press the Tune +/- buttons to adjust the hour.
3. Press the Clk set button again to adjust the minutes. The minutes on the display will begin
flashing.
4. Press the Tune +/- buttons to adjust the minutes.
5. Press the Clk set button to finish setting the time, or wait for the display to stop flashing.
Setting the Timer
1. With the power off, press the Timer button. The display will flash.
2. Press the Timer buttons to adjust the timer in increments of 10 min.
3. Press the Tune +/- buttons to adjust the timer in increments of 1 min.
4. Wait for the display to stop flashing.
5. After the set time has expired, the under cabinet music system will sound an alarm.
Disabling the Timer
To cancel the alarm after it has sounded, press the Power button.
To cancel the timer before the alarm has sounded, press the Timer button until the display
reads 000 and the timer light is no longer lit.
Note: This unit is not compatible with MP3 CDs.
Loading and Playing a CD
1. Open the CD door.
2. Place a CD into the tray, label side facing up.
3. Close the CD door.
4. Press the Source button to switch to CD mode.
5. Press the Play/Pause button to begin playing the loaded CD.
6. Press the Skip/Tune buttons to cycle through tracks.
Programming a CD
1. Press the Stop button to stop the CD during play.
2. Press the Prog button.
3. "PROG" will begin to blink on the display.
4. Press the Tune +/- buttons to select a track.
5. Press the Program button to save the selected track to the program.
6. Repeat steps 4 and 5 to program up to 20 tracks.
6

CLOCK AND TIMER

CD