Igloo BTC511 Instruction Manual page 5

7 Clean the appliance and attachments thoroughly. Refer to the "care & maintenance"
section".
8 Position the appliance on a level,dry,clean and heat-resistant surface at least 75cm above
floor level.
9 Leave a clear space of at least 5cm all around the appliance.
10 Do not use the beverage machine outdoors, particularly when temperatures exceed
30°C.
11 Centre the drip tray under the front of the appliance.
12 Put a plastic mat underneath the appliance to protect the work surface from scratches
and drips.
13 Have a bucket and towel handy in case of frothing or spillage and wear old clothes that
you don't mind getting beer on.
CO² cartridge
Your beverage machine can be operated without a CO² cartridge, however
use CO² when preparing your favourite drinks to improve their quality. Adding CO²
can
results in the formation of bubbles in the beer and better frothing.
CO² cartridges can be obtained from our after-sales service only in France on 0820 200 275.
Customers in Belgium can obtain then from their local electrical goods store – 320g CO2
cartridge.
One cartridge can be used for several kegs of beer.
A set of accessories used to connect the cartridge to the appliance are provided with your
beverage machine.
Positioning and connecting the CO² cartridge
Ensure that the tap is closed before screwing the pressure gauge on to the CO² cartridge.
Insert the whole piece – cartridge and pressure gauge – into the black plastic shell.
Position the shell, using the hook located at its base, to the rear of the machine, in the
opening in the casing of the appliance.
Using the socket connection on the tap connect the cartridge to the metal outlet to the
rear of the machine near the lid.
Using the CO² cartridge:
The air pump must not be used whilst the CO² cartridge is in use. In this case, the cartridge
will provide the pressure required for the beverage to flow.
We would recommend that you set the pressure between 1.5 bars and 2 bars using the
pressure gauge located on the cartridge. The outlet must only be opened once the keg
has been completely connected to the machine.
N.B.The tube coming from the adaptor fastened to the keg must be connected to the metal
' CO2' tube.
5
some models