Table of Contents
Advertisement
C H A P T E R 3
Startup and Shutdown Procedure
Refer to the Installation Manual to secure the unit and install AC and DC wiring.
For the initial startup of the system, follow the instructions in the Startup and Warranty
Validation Form. Failure to do so will void warranty.
CAUTION: HAZARDOUS VOLTAGES – ONLY QUALFIED SERVICE PERSONNEL SHOULD PERFORM
1.
Verify that the installation switch located on the inverter chassis is in the OFF
position. Verify that AC input is disconnected.
2.
Press and hold the DC Pre-charge switch located on the inverter chassis for
approximately five seconds and then install the battery fuse. If a large flash
occurs, the batteries are not connected properly. Call service immediately.
3.
Energize the Mains AC input by turning on the units input circuit breaker and/or
the Distribution Panel breaker located upstream from the inverter.
4.
Turn the installation switch to the ON position. The Front Panel display should
now be illuminated and a slight hum should be heard from the inverter
transformer. The unit is now charging and the output should be energized.
1.
Interrupt the AC Mains to the machine by the Distribution Panel Breaker or the
machines input circuit breaker. The Inverter should then start.
2.
Turn the installation switch located on the inverter chassis to the off position. The
inverter should stop.
3.
Disconnect the main battery fuse located on the inverter chassis.
CAUTION: HAZARDOUS VOLTAGES STILL EXIST AT THE BATTERY TERMINAL
BLOCK AND WITHIN THE SYSTEM. AUTHORIZED SERVICE TECHNICIANS MUST
DISCHARGE DC CAPACITORS AND TURN OFF UTILITY POWER BEFORE
CAUTION: DO NOT LEAVE THE SYSTEM SHUTDOWN FOR A PROLONGED LENGTH
OF TIME. LEAD BASED BATTERIES WILL EXPERIENCE PERMANENT DAMAGE
7
STARTUP PROCEDURE
PROCEDURE.
SHUTDOWN PROCEDURE
SERVICING EQUIPMENT.
FROM LACK OF CHARGING AFTER A FEW MONTHS.
114195 – System Users Manual
Advertisement
Table of Contents
