SailRC RC Laser User Manual
  1. Manuals
  2. Brands
  3. SailRC Manuals
  4. Toy
  5. RC Laser
  6. User manual

SailRC RC Laser User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Enlarged version
R A D I O C O N T R O L L E D
©2003 Out There Technologies
Laser is a registered trademark of
Vanguard, Inc., Performance Sailcraft,
and Performance Sailcraft, Pty
R A D I O C ON T R OL L E D
R
a u s e r ' s m a n u a l
LOA: 41.5" (105.41cm)
LWL: 37.75" (95.88cm)
DSPL : 9 lbs (3.4kg)
BEAM: 13.125" (33.33cm)
MAIN HOIST: 52" (132.08cm)
DRAFT: 16" (40.64cm)
SAIL AREA: 710 sq "
(4580.63sqcm)
DESIGNED BY BRUCE KIRBY
DEVELOPED BY JON ELMALEH
R

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RC Laser and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SailRC RC Laser

  • Page 1 R A D I O C ON T R OL L E D a u s e r ' s m a n u a l LOA: 41.5" (105.41cm) LWL: 37.75" (95.88cm) DSPL : 9 lbs (3.4kg) BEAM: 13.125" (33.33cm) MAIN HOIST: 52"...
  • Page 2 warranty There is a six-month limited warranty on parts damaged during normal use (While sailing and does not included hitting other boats or obstructions). You must register by mailing the warranty card within 10 days of purchase to be eligible for the warranty.
  • Page 3 Congratulations on your purchase. We hope the RC Laser will fulfill all your expectations. We have worked hard to make this product the best RC sailboat on the market today, and we believe the RC Laser is the one-design sailboat that sailors are looking for.

  • Page 4: Table Of Contents

    TABLE OF CONTENTS The RC Laser and Components ..........Parts Layout ................Assembly: Overview ................Details: Sail and Mast ................Keel ................Rudder ................ Batteries ..............Antenna ..............Rig ................Sheet Line ..............Transmitter ..............Rudder Control ............Sail Control ..............

  • Page 5: The Rc Laser And Components

    If you intend to race your RC Laser, you may not change your boat in any other way other than to decorate it as explained in this manual. All replacement parts must be genuine RC Laser parts.

  • Page 6: Parts Layout

    Parts Layout TELL TALE SAIL SHEET LINE MAST BOOM GOOSENECK BOOM SLIDERS HATCH COVER POWER SWITCH KEEL LOCK SCREW EYE RUDDER BRACKET ANTENNA TUBE ANTENNA MOUNT RUDDER KEEL...

  • Page 7: Assembly Overview

    ASSEMBLY OVERVIEW RC LASER RESOURCES (See following pages for detailed instructions) 1) Assemble rig by connecting mast Distributors tubes and sliding assembled mast into sail pocket. Slide boom into gooseneck. Model Sailing Center 2) Insert keel into slot at 290 Circle Drive...

  • Page 8: Sail And Mast

    Lap 1 1 SAIL AND MAST Windward buoy Offset buoy wind direction Starting gate START Here’s a course that offers a lot of opportunities to make c h o i c e s a n d t h i n k a b o u t strategy, because there are a number of different paths A) Connect mast tubes.

  • Page 9: Keel

    2 KEEL RACING YOUR RC LASER There is an infinite number of possible race courses you can Rotate locking lever 90 degrees until lever locks in place. sail - the only limit is your imagination. Here are two of the more commonly used courses to get you started.

  • Page 10: Batteries

    Remove hatch cover. Take out battery holder. Check switch on boat to wind direction make sure it is in the off position. Install four "AA" batteries. Replace battery holder and hatch cover. Do not put your RC Laser into the water without its hatch cover. Damage may result. Head to wind...

  • Page 11: Rig

    4. Luffing Rights Rule 6 RIG Slide rig (mast and sail) into mast hole on deck. This rule applies when you are passing another boat at close proximity. Figure F indicates the windward and leeward sides of a boat. On the starboard tack, the starboard side of the boat is the windward side.

  • Page 12: Transmitter

    A boat that makes contact with a buoy must sail away from the fleet, out of The transmitter is the device that enables you to control your RC Laser from the way of other boats, and do a 360-degree penalty turn(figure E). After the shore.

  • Page 13: Sail Control

    Figure B Sail stick Your RC Laser is powered by the wind, not by your radio. However, the sail stick on your transmitter enables you to let the sail in and out to maximize your boat’s use of wind power (see “How to Sail”). As you move the sail stick...

  • Page 14: Radio Frequencies

    Sailboat racing is a lot of fun. If you are already familiar with yacht racing The frequency of your RC Laser is indicated on the end flap of the box. Each rules, those rules can be used when racing the RC Laser. Even if you know RC Laser comes with a set of removable crystals.

  • Page 15: Boat Care / Radio Care / Batteries

    Use a blow dryer to dry wet begins to luff. Next, pull it in until the luffing stops. equipment. Now you should be ready to put your RC Laser in the water. good luck and Batteries good sailing!

  • Page 16: Sail And Boat Numbers

    Decoration Sail and Boat Numbers There are two ways to add color to your boat without violating the one-design Sail numbers may or may not be included with your boat. They are primarily rule that boats cannot be altered: magic markers or PVC tape only. Vinyl tape used for racing.

Table of Contents