ALL EQUIPMENT MUST BE TURNED OFF AND DISCONNECTED FROM THE MAINS BEFORE
7.
CONFIGURE THE TV
The DVD player is set to UK PAL TV type as standard; if NTSC is required, see section 20 for set up.
7.1
Place the DVD player horizontal on a flat level surface.
7.2
Connect the DVD player to your TV and / or audio system (as shown in the previous diagrams), plug in
and switch on at the mains.
7.3
Insert the batteries into the remote control.
7.4
Press the POWER button on the DVD player to turn on the player (the power indicator at the side of the
button will illuminate) and turn on the TV and amplifier (if connected).
7.5
Select the video mode (AV) for the TV. If there is more than one video channel (AV1, AV2, etc) select the
source that the DVD player is connected to. See the TV instruction manual for tuning instructions if the set
does not automatically tune.
CAUTION !
INSTALLATION
6