Advertisement
UPS Front Panel (Figure 3):
NOTE: Symbols & functions may differ on some UPS models.
Figure 4 illustrates some of the variations in displays.
Please use the illustration which best resembles your UPS.
POWER 'ON/OFF' &/OR TEST BUTTON
1
Button to turn UPS on or off, or perform a self-test.
POWER 'ON/OFF' SWITCH
2
on or off. The switch will illuminate when power is
present on the output receptacles.
TEST SWITCH
power, the top part of the switch will cause the UPS
to simulate a power outage.
3
ALARM DISABLE SWITCH
on battery, the bottom part of the switch will disable
the audible tone.
UPS Outlets (Figure 4):
NOTE: Panel Layout may differ
depending on model.
1
DB9 Serial Port
Site wiring fault Indicator
2
Modem/Phone/FAX/Network
3
surge protection
Circuit breaker/Overload
4
protection
UPS input
5
Outlets
6
7
Battery Disconnect
8
Option Switches
Option Switch configuration (Figure 4, reference #8):
NOTE: Option switch may not be included on some models. 'Shutdown Settings' function is only available on 500 & 650 VA models.
UTILITY TRANSFER VOLTAGE
Position:
(NORMAL SETTING) 103V AC
C B M _ O T Q G _ B U 3 _ 2 0 1 1 0 8 0 9 V 0 2
3
2
- Switch to turn UPS
- When operating on Utility
- When operating
1
6
7
Result:
98V AC
93V AC
88V AC
2
ONLINE
-
4
connected equipment. If not lit, the UPS is not turned
ON, or is supplying battery power.
ON BATTERY
5
power to the connected equipment. UPS will beep four
times every 30 seconds.
OVERLOAD
6
exceeded the capacity of the UPS. A sustained alarm
tone is also emitted.
REPLACE BATTERY
battery is bad. UPS makes short beeps for a minute.
7
BATTERY DISCONNECTED
the battery is disconnected. UPS will beep every two
seconds.
2
3
4
5
Position:
(NORMAL SETTING) AUDIO is enabled.
SHUTDOWN SETTINGS
Position:
(NORMAL SETTING) 2 min. prior to shutdown, UPS will
sound a tone & activate low battery signal on COM port.
Same actions as "NORMAL SETTING", but delay is
increased to 5 minutes instead of 2 minutes.
1
4
7
5
- UPS is supplying utility power to the
- UPS is supplying battery backup
- The power demand from the load has
- UPS fails a self-test, or
- Flashes to indicate
1
8
3
6
AUDIO SETTING
Result:
AUDIO is disabled.
Result:
6
Figure 3
2
4
5
Figure 4
Page 2
Advertisement
