US Water Systems USCRO-350 Installation And Operation Manual

Us water 350 & 700 gpd light commercial ro systems

Advertisement

Quick Links

Light   C ommercial   R O   S ystems
INSTALLERS: PLEASE READ ALL INSTRUCTIONS BEFORE IN-
STALLING AND USING THIS SYSTEM.
IT IS RECOMMENDED TO WAIT UNTIL THE ENTIRE SYSTEM IS
PRESSURIZED AND RE-CHECK FOR ANY LEAKS BEFORE LEAV- ING
INSTALLATION SITE.
IT IS NORMAL FOR SOME BLACK CARBON FINES TO APPEAR IN
THE WATER WHEN EMPTYING THE FIRST 2 TANKS OF WA- TER.
THE FIRST 2 TANKS OF WATER PRODUCED SHOULD BE EMPTIED
AND NOT USED.
REVISION #
3
REVISION DATE June 4, 2014
US   W ater   3 50   &   7 00   G PD    
 
 
 
 
 
 

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the USCRO-350 and is the answer not in the manual?

Questions and answers

Summary of Contents for US Water Systems USCRO-350

  • Page 1 US   W ater   3 50   &   7 00   G PD     Light   C ommercial   R O   S ystems             INSTALLERS: PLEASE READ ALL INSTRUCTIONS BEFORE IN- STALLING AND USING THIS SYSTEM.
  • Page 2: Specifications

    Table of Contents PAGE Specifications How Your System Works Before You Start Installing Tubing Into Fittings Installing the Membrane Installing the Filters & Connections Electrical Diagrams Flow Diagrams Parts List Trouble Shooting Warranty Specifications Max.   Dimensions   Qty   Operating  ...
  • Page 3: Before You Start

          Before You Start Your system contains filters which must be replaced periodically for proper operation. (Read all steps and guides carefully before installing and using your RO system. Follow all steps exactly to correctly install. The system is designed to be used on potable water supplies only. If water is non-potable, additional pre- treatment will be required.
  • Page 4 Installing the Filters & Connections When handling filter cartridges be sure hands are clean and sanitized or wear surgical gloves. Loosen and remove filter housings using wrench provided. Remove plastic wrapper from filter cartridges. Check the o-ring to insure it is lubricated. If not, use NSF approved silicon grease.
  • Page 5: Electrical Diagrams

    Electrical Diagrams USCRO-350 USCRO-700...
  • Page 6 Flow Diagrams USCRO-350 USCRO-700...
  • Page 7 Parts List USCRO-350 USCRO-700...
  • Page 8: Troubleshooting

    Trouble Shooting PROBLEM CAUSE SOLUTION No   p roduct   w ater. 1.   W ater   s upply   i s   t urned   o ff. 1.   T urn   o n   f eed   w ater. Not  ...

This manual is also suitable for:

Uscro-700

Table of Contents