Wheel Drive Clutch Lever & Traction; Section 5 - Handlebars & Controls; Lower Handlebar; Attachment Clutch Handle - Ariens 924 SNO-THRO 924108 Service Manual

3

5.1 LOWER HANDLEBAR

Remove nut and washer attaching lower handlebar to
each side of frame and remove lower handlebar.
Check parts for wear or replacement.
Assemble, using reverse procedure.

5.2 ATTACHMENT CLUTCH HANDLE

Remove (2) push nuts, pin and (2) screws holding
Clutch Handle and pivot to upper handlebar. Remove
pivot and disconnect Clutch Handle from clutch cable.
Remove set screw, jam nut and clevis from clutch
cable.
Remove pin and remove cable.
Disconnect spring from lever.
Check parts for wear or replacement.
Assemble using reverse procedure.
SECTION 5 - HANDLEBARS & CONTROLS
2
1
11
9
10
8
4
7
1. Chute Crank Handle
2. Speed Selector Lever
6
3. Set Screw
4. Chute Deflector Remote
5. Attachment Clutch Arm
6. Clutch Cable Spring
5
7. Clutch Cable
8. Traction Clutch Arm
9. Speed Selector Rod
10.Rod Adapter
11.Traction Clutch Cable
Figure 12
5.3 WHEEL DRIVE CLUTCH LEVER &
TRACTION CABLE
Remove (2) push nuts, pin, and (2) screws holding
pivot and wheel drive clutch lever to upper handle bar.
Remove pivot and wheel drive clutch lever.
Remove set screw, nut, hair pin and clevis pin holding
the clevis to traction clutch cable.
Remove set screw in rod adapter and remove traction
clutch cable.
Check parts for wear or replacement.
Assemble using reverse procedure.
5 - 18
DS0161