Tape Deck - Sony LBT-XB8AVKS Operating Instructions Manual

CD Player
The CD tray does not rotate.
• A CD is not placed properly.
A CD will not play.
• The CD is not lying flat in the disc tray.
• The CD is dirty.
• The CD is inserted label side down.
• Moisture condensation has built up.
Remove the CD and leave the system
turned on for about an hour until the
moisture evaporates.
Play does not start from the first track.
• The player is in Program or Shuffle Play
mode. Press PLAY MODE repeatedly
until "PROGRAM" or "SHUFFLE"
disappear from the display.

Tape Deck

The tape does not record.
• No tape is in the cassette holder.
• The tab has been removed from the
cassette (see page 43).
• The tape has reeled to the end.
The tape does not record nor play, or there
is a decrease in sound level.
• The heads are dirty. Clean them (see page
43).
• The record/playback heads are
magnetized. Demagnetize them (see page
43).
The tape does not erase completely.
• The record/playback heads are
magnetized. Demagnetize them (see page
43).
There is excessive wow or flutter, or the
sound drops out.
• The capstans or pinch rollers are dirty.
Clean them (see page 43).
Noise increases or the high frequencies are
missing.
• The record/playback heads are
magnetized. Demagnetize them (see page
43).
Tuner
Severe hum or noise ("TUNED" or
"STEREO" flashes in the display.
•Adjust the antenna.
•The signal strength is too weak. Connect
an external antenna.
A stereo FM program cannot be received in
stereo.
•Press STEREO/MONO so "STEREO"
appears in the display.
If other problems not described
above occur, reset the system as
follows:
1 Unplug the power cord.
2 Plug the power cord back in.
3 Press SPECTRUM ANALYZER, ENTER,
and DISC 1 at the same time.
45