Steering Trim - JRRacing XR2i Manual

5189 JR XR-2i manual 9/18/02
Steering Trim (STC)
The XR2i electronic Steering Trim lever, located just
above the steering wheel, allows the center position of
the servo to be manipulated in either direction to
achieve precise centering of the steering assembly.
Steering travel end-point adjustment values (page 24)
remain completely independent from the steering
trim, unless the trim value exceeds the selected end-
point values. (For example, if trim values are set at
30 and end-point values at 15, steering trim will
over-ride/alter the end-point value.)
stc
T R I M .
Values: L/F 60 0
CLEAR
INCREASE
Press the Increase and Decrease keys at the same
time to reset the throttle trim value to zero.
Each click will provide 0.3° of trim to the center of the
steering servo with a maximum of 12° allowed.
Note: Each click will not always result in a
change of the value displayed.
22
12:01 PM Page 22
0
Current Value
R/B 60
DECREASE
To adjust the steering trim servo position, move the
electronic Steering Trim lever either to the left or the
right. As soon as the trim is moved, the "STC"
Steering Trim screen will appear and will continue to
be displayed unless the trim lever is untouched for a
period of two seconds. To reset the trim value to 0,
press the Increase and Decrease keys at the same
time while the "STC" screen is displayed.
Increase
Decrease
Throttle Trim Location
ST.