Table of Contents
Advertisement
3 Installation
3.1 Device Installation
This series IPC can be put on the table to realize surveillance. Or you can use the bracket or the in-
ceiling installation to realize the hang function. Please refer to the steps listed below.
Step1
Use the inner hexagonal wrench (provided) to loose the three inner hexagon screws in the dome cover
and then open the cover.
Step 2
Please take the installation position map in the accessories bag, and then paste it on the ceiling or the
wall according to your monitor area requirements. Draw and then dig three plastic expansion bolts
holes in the installation surface and then insert three expansion bolts in the holes. Secure these three
bolts firmly. Please dig a "cable exit hole" in the surface according to the installation position map if
you want to draw out the cable from the top of the installation surface. You need to use the proper tool
to open up the side port of the U-cable channel of the dome camera pedestal if you want to draw out
Figure 3-1
Figure 3-2
12
Advertisement
Table of Contents
