Table of Contents
Advertisement
Quick Links
Table of Contents
1. Introduction------------------------------------------------------------------------------------------- 3
2. Important Instructions------------------------------------------------------------------------------ 4
2.1 Note on the warranty------------------------------------------------------------------------ 4
2.2 Exclusion of Accident Liability Obligation---------------------------------------------- 4
2.3 Liability Limitation / Exemption from the Warranty Obligation----------------------4
3. Safety Instructions----------------------------------------------------------------------------------- 5
3.1 Electrostatic Discharge (ESD)------------------------------------------------------------- 6
3.2 Grounding Methods--------------------------------------------------------------------------6
IP65 All-In-One Fan-less Panel PC
American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide
User Guide
17" IP17ID7T-M1-5RT
Page 1
Advertisement
Table of Contents
Troubleshooting
Subscribe to Our Youtube Channel
Related Manuals for AIS IP17ID7T-M1-5RT
Summary of Contents for AIS IP17ID7T-M1-5RT
- Page 1 2.3 Liability Limitation / Exemption from the Warranty Obligation----------------------4 3. Safety Instructions----------------------------------------------------------------------------------- 5 3.1 Electrostatic Discharge (ESD)------------------------------------------------------------- 6 3.2 Grounding Methods--------------------------------------------------------------------------6 User Guide IP65 All-In-One Fan-less Panel PC 17” IP17ID7T-M1-5RT American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 1...
- Page 2 The information contained in this document is subject to change without notice. This document contains proprietary information that is protected by copyright © 2013 American Industrial Systems. All rights are reserved. No part of this document may be reproduced, translated to another language, stored in a retrieval system, or transmitted by any means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission.
-
Page 3: Table Of Contents
Table of Contents Introduction ............................. 6 Important Safety Instructions ......................7 2.1 Electrostatic Discharge (ESD) ......................8 2.2 Grounding Methods..........................8 2.3 FCC Statement............................. 8 2.4 Electromagnetic Capability ......................... 8 2.5 Important LCD Information......................... 9 Packaging List..........................10 Product Description ........................11 4.1 General Information .........................11 4.2 Features ............................ - Page 4 8.4.4 Ethernet Interface........................21 8.4.5 USB Ports............................ 21 8.4.6 Audio Jack (Pin-header) ......................21 8.5 Jumpers and Connectors........................22 8.6 Jumper Settings..........................23 8.6.1 JP1: RS232/RS422/RS485 Selector for CON Port ............... 24 8.6.2 JP2: RS232/RS422/RS485 Selector for CON Port ............... 24 8.6.8 JP3: LCD Panel Voltage Select ....................25 8.6.6 JP4: Back Light PWR ........................25 8.6.3 JP5: Clear CMOS .........................25 8.6.7 JP6: PWM Level..........................25...
- Page 5 10.1 Standard CMOS Features ........................34 Ethernet Driver Installation ......................35 11.1 Installation of Ethernet Driver ......................35 Audio Driver Installation ........................38 12.1 Installation of the Audio Driver....................... 38 LCD Display Operation ........................39 13.1 Simple Troubleshooting Guide......................39 13.1.1 Brief FAQ ..........................39 13.1.2 Additional Troubleshooting Chart: ..................40 Appendix ............................
-
Page 6: Introduction
Introduction This user manual is designed for American Industrial Systems, Inc. Included is a comprehensive overview of the systems designed by American Industrial Systems. All rights are reserved. None of this document shall be duplicated, stored in a retrieval system, or transmitted by all means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of American Industrial Systems, Inc. -
Page 7: Important Safety Instructions
Important Safety Instructions This chapter also includes information on approval and interference inhibition of your unit. Please abide by the warnings and instructions on the unit and in the manual. Please read these instructions carefully before using the product and save it for later reference. ... -
Page 8: Electrostatic Discharge (Esd)
2.1 Electrostatic Discharge (ESD) A sudden discharge of electrostatic electricity can damage electrostatic-sensitive devices or circuit. Adequate packaging and grounding techniques are essential fundamentals to avoid damage. The following precautions should be always taken: 1. Deliver printed circuit boards in electrostatic-safe containers such as cartons, boxes or anti-static bags. -
Page 9: Important Lcd Information
2.5 Important LCD Information American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 9... -
Page 10: Packaging List
Packaging List Item Description Note 1 User Manual 1 CD for Touchscreen Drivers & Tools 1 Power Cord American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 10... -
Page 11: Product Description
Product Description 4.1 General Information AIS pre-designed and open-based HMIs, 17" inch (1280 x 1024 SXGA) all-in-one panel PC computers or operator control panels with fan-less design and IP65/NEMA 4/4x rating designed which provide cost effective control interface which can be easily integrated into new and existing machinery installations,... -
Page 12: Mechanical Drawings
Mechanical Drawings American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 12... -
Page 13: Touch Screen Solution
Touch Screen Solution 6.1 Introduction to Five-Wire Resistive Touch Screen The five-wire resistive touchscreens use a glass panel with a uniform resistive coating. A thick polyester coversheet is tightly suspended over the top of the glass, separated by small, transparent insulating dots. The coversheet has a hard, durable coating on the outer side and a conductive coating on the inner side. -
Page 14: Installing The Display
Installing the Display 7.1 Signal Cable 7.1.1 VGA Signal Shielding Cable Connection 1. Plug one end of the 15-pin signal cable to the video signal connector at the rear end of the PC system and the other end of the cable to your military display. 2. -
Page 15: Starting The Panel Pc
7.3 Starting the Panel PC Connect the power to 12 V DC Power Supply to 3 pins Terminal Block (Phoenix Type) American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 15... -
Page 16: Vesa Wall Mount Installation
7.4 VESA Wall Mount Installation This monitor conforms to the VESA Flat Panel Mounting Physical Mounting Interface standard which defines a physical mounting interface for flat panel monitors. It also corresponds with the standards of flat panel monitor mounting devices, such as walls and table arms. The VESA mounting interface is located on the back of your monitor. -
Page 17: Motherboard
Motherboard The ID70 SBC is integrated with Intel® NM10 express chipset, 17x17mm, and Atom D2700 Processor. Intel Atom Processor with 32nm low power design enables down to 50% less average power consumption and the chipset delivers up to 4x improvement in graphics performance and enables up to 50% higher data transfer bus speed rate. - Page 18 Function Block American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 18...
-
Page 19: Motherboard Specifications
8.1 Motherboard Specifications American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 19... -
Page 20: Board Dimensions
8.2 Board Dimensions American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 20... -
Page 21: Motherboard Installation
8.3 Motherboard Installation 8.3.1 Memory Module (SO-DIMM) Installation The ID70 Motherboard provides one 204-pin SODIMM slot. The socket supports up to 4GB DDR2 800/1066 SDRAM. When installing the Memory device, please follow the steps below: 1. Step.1. Firmly insert the SO-DIMM at an angle into its slot. Align the SO-DIMM on the slot such that the notch on the SO-DIMM matches the break on the slot. -
Page 22: Jumpers And Connectors
8.5 Jumpers and Connectors American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 22... -
Page 23: Jumper Settings
8.6 Jumper Settings A jumper is a metal bridge that is used to close an electrical circuit. It consists of two metal pins and a small metal clip with a plastic cover. To CLOSE, connect the jumper. To OPEN, leave the jumper off. A pair of needle-nose pliers may be helpful when working with jumpers. -
Page 24: Jp1: Rs232/Rs422/Rs485 Selector For Con Port
connections. The jumper setting diagram is as below. If a jumper shorts pin 1 and pin 2, the setting diagram is shown as the right one. The following tables list the function of each of the board’s jumpers. 8.6.1 JP1: RS232/RS422/RS485 Selector for CON Port The jumper can be configured to operate COM1 in RS-232/422/485 mode. -
Page 25: Jp3: Lcd Panel Voltage Select
8.6.8 JP3: LCD Panel Voltage Select 8.6.6 JP4: Back Light PWR 8.6.3 JP5: Clear CMOS 8.6.7 JP6: PWM Level 8.6.5 JP7: Brightness Control (DC/PWM) 8.6.4 JP8: Brightness Control (VR/Software) 8.7 Connectors and Pin Assignment The table below lists the function of each of the board’s connectors. American Industrial Systems –... - Page 26 American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 26...
-
Page 27: Con1: Lvds Connector
8.7.1 CON1: LVDS Connector 8.7.2 CN16: Digital Panel Backlight Brightness Control 8.7.3 CN19: Inverter Power American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 27... -
Page 28: Com5-6: Dual Output
8.7.4 COM5-6: Dual Output 8.7.5 5V/12V/CN10: External Power 8.7.6 USB: USB PIN HEADER 8.7.7 PANEL Connector: Front Panel System Function Connector American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 28... -
Page 29: Com2: Serial Port Com2
8.7.8 COM2: Serial port COM2 8.7.9 DIDO1: Digital I/O Connector 8.7.10 J2/J3: Amplifier American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 29... -
Page 30: Dvi1: Dvi Connector
8.7.11 DVI1: DVI Connector 8.7.12 CPU: FAN CONNECTOR Graphic Driver Installation 9.1 Standard CMOS Feature ID30 Motherboard is equipped with Intel NM10 Companion Device. The Intel Graphic Drivers should be installed first, and it will enable the “Video Controller” (VGA compatible). Follow the instructions below to complete the installation. -
Page 31: Panel Resolution Setting
2. Click on “setup” to execute the setup 3. Follow the on-screen instructions. 9.2 Panel Resolution Setting 1. Right-click the desktop, and then click properties. 2. In the Display Properties dialog box, click the Settings tab. American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 31... - Page 32 3. Click on “Monitor” 4. Click on “Hide modes that this monitor cannot display” to remove this option. American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 32...
- Page 33 5. Click on “Setting,” then choose 32bit color quality if you would like. American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 33...
-
Page 34: Chipset Driver Installation
Chipset Driver Installation 10.1 Standard CMOS Features 1. Insert the CD that comes with the motherboard. Open the file document “Chipset Driver.” 2. Click on “infinst_auto.exe” to install the driver. 3. Follow the on-screen instructions. American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 34... -
Page 35: Ethernet Driver Installation
Ethernet Driver Installation 11.1 Installation of Ethernet Driver Make sure which operating system you are using in the ID30 Motherboard before installing the Ethernet drivers. Follow the steps below to complete the installation of the Broadcom BCM57780 Gigabit Ethernet controller LAN drivers. 1. - Page 36 4. Click on “Browse my computer for driver software” to install the driver. 5. Choose the path to install the driver. American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 36...
- Page 37 6. Click on “Close” and go on. 7. Follow the on-screen instructions to complete the installation. American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 37...
-
Page 38: Audio Driver Installation
Audio Driver Installation The ALC888 series are high-performance 7.1+2 Channel High Definition Audio Codecs providing ten DAC channels that simultaneously support 7.1 sound playback, plus 2 channels of independent stereo sound output (multiple streaming) through the front panel stereo outputs. The series integrates two stereo ADCs that can support a stereo microphone, feature Acoustic Echo Cancellation (AEC), Beam Forming (BF), and Noise Suppression (NS) technology. -
Page 39: Lcd Display Operation
LCD Display Operation 13.1 Simple Troubleshooting Guide 13.1.1 Brief FAQ 1. What if the display has no power after you push the power button? a. Make sure your power resource is working and your power cord is securely connected into the plug-in. b. -
Page 40: Additional Troubleshooting Chart
13.1.2 Additional Troubleshooting Chart: For more information, please go to the website http://www.aispro.com and contact technical support to help resolve your issue. You can also e-mail support at support@aispro.com. We will be happy to help. American Industrial Systems – IP65 All-In-One Fan-less Panel PC User Guide Page 40... -
Page 41: Appendix
Appendix 14.1 Cleaning the Monitor 1. Make sure the monitor is turned off. 2. Never spray or pour any liquid directly on the screen or case. 3. Wipe the screen with a clean, soft, lint-free cloth. This removes dust and other particles. 4. -
Page 42: Touch Screen Driver Installation
14.2 Touch Screen Driver Installation The monitor is available with USB connection. The Linux kernel 2.6.x (32 bit & 64 bit) touch driver is located on the enclosed CD-ROM. HID for Windows® 7, VISTA , XP, 2000, ME, 98. Please Note: The system requires 15 seconds for Windows®... -
Page 43: Rma (Return Material Authorization) Service
2. Describe the behavior or reason of unit failure in order to return. Any returns for credit are subject to a restocking fee. 3. Upon confirmation of a hardware failure or valid cause for return, AIS will provide a Return Merchandise Authorization (RMA).
Need help?
Do you have a question about the IP17ID7T-M1-5RT and is the answer not in the manual?
Questions and answers