Assembly And Use - Kalorik FP 39794 Operating Instructions Manual

Citrus juicer
Table of Contents

Advertisement

Available languages

Available languages

Fax +1 305 430 9692
IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the
requested breaks. Failure to follow this instruction carefully may result
in damage to the motor. The maximum continuous usage time is 1
minute. After 1 minute of continuous use, you should insert a break of
at least 10 minutes. We recommend to work by cycles: 15 seconds
on / 15 seconds of break, for 10 cycles maximum.

ASSEMBLY AND USE

Check prior to any assembly or disassembly that the power cord
is not connected to the wall outlet.
Make sure the rotating shaft (c) is well in place and inserted into
the base (d)
Note: the shaft is removable, if this is needed for cleaning
Put the pitcher (b) on the base (d), inserting the notches at the
bottom of the pitcher into the grooves of the base, and turn the
pitcher clockwise to lock it in place.
Put the strainer assembly (g + h) in the correct position, on top of
the pitcher.
Put the small reamer (f) on the shaft (c) of the base.
Plug in the appliance, by inserting the plug in a wall outlet.
Cut the citrus in 2 pieces, cutting across sections.
Press gently each half of the fruit on the cone. The citrus press will
start operating automatically, by turning to the right or to the left.
Stop pressing on the reamer and the operation will stop
automatically too.
If the fruit is too big (orange, grape fruit), please use the big
reamer by putting it aver the smaller one. The 2 gaps at the
bottom of the big reamer must be placed over the 2 wings of the
small reamer.
Once all the juice has been extracted, remove the pitcher, simply
by turning it counter-clockwise and lifting it from the base. Now
you can pour the juice into a glass and enjoy a delicious, fresh
cup of juice.
When finished, unplug the power cord from the wall outlet.
Copies of the I/B. Please reproduce them without any
changes
except
under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
5
Assembly page 5/24
special
instruction
from
Team
FP 39794 - 120501

Advertisement

Table of Contents
loading

Table of Contents