Table of Contents
Advertisement
Appendix A
Figure A.4 Outer rail and attached bracket
A - 4
If the rack is a round-holed rack, use your own standard rack screws to
attach the rail and bracket directly to the rack.
If the rack is a square-holed rack, you must use the additional, separate
brackets included in the kit to attach the rail and bracket to the rack.
To attach the outer rails to the rack
1. Find the upper rail that corresponds to the side of the rack onto
which you are installing the rail.
2. Attach the outer rail and bracket onto the rack as shown in Figure
A.5. Note the following:
a) If the rack is a round-holed rack, use standard rack screws.
b) If the rack is a square-holed rack, hang one of the separate
brackets provided with the kit onto each end of an outer rail, and
then use the screws provided to attach each rail onto the rack. To
accomplish this task, you will use a total of four separate brackets
(two per rail), and eight screws (two per bracket).
Figure A.5 shows a rack with an outer rail attached.
Advertisement
Table of Contents
