Advertisement
SAFETY WARNING
THE POWER AMPLIFIER SHOULD ALWAYS BE
CONNECTED TO THE MASTER CABINET ONLY.
NEVER CONNECT A POWER AMPLIFIER
OUTPUT DIRECTLY TO THE LINK CONNECTION
ON THE SLAVE CABINET.
THE GEMINI 1-P-SP LOOPBACK PLUG SHOULD
ONLY BE USED IN THE GEMINI 1-P-SP MASTER
LINK CONNECTOR FOR ENABLING SOLO
MODE. NEVER CONNECT THE LOOPBACK
CONNECTOR TO ANOTHER DEVICE AS SHORT
CIRCUIT MAY OCCUR.
EcifiÊ tions
Power Handling, Series Pair Mode: 500W RMS
Power Handling, Solo Mode: 250W RMS
Frequency Response: 66Hz - 20KHz +_ 2dB
Crossover: Passive at 2.5KHz
Impedance: 16 Ohm in Series Pair Mode
Impedance: 8 Ohm in Solo Mode
Input: Combo Speakon ¼" jack
Link: Combo Speakon ¼" jack
Mission Enginî ring Inc.
www.missionengineering.com
info@missionengineering.com
©
Mission Engineering Inc. 2014. All rights reserved. GEMINI 1-P-SP
is a Trademark of Mission Engineering Inc. Trademarks, registered
trademarks, product names, logos and other materials are the
property of their respective owners.
MISSION
ENGINE
GEmini 1-P
S
PAir
U
Guide
ING
i
r
Advertisement
Table of Contents
Related Manuals for Mission Gemini 1-P series
Summary of Contents for Mission Gemini 1-P series
- Page 1 Mission Enginî ring Inc. www.missionengineering.com info@missionengineering.com © Mission Engineering Inc. 2014. All rights reserved. GEMINI 1-P-SP Guide is a Trademark of Mission Engineering Inc. Trademarks, registered trademarks, product names, logos and other materials are the property of their respective owners.
- Page 2 To use the Gemini 1-P-SP in Series Pair Mode: 1. Connect the output of your power amplifier to The Gemini 1-P-SP is a matched pair of Gemini 1-P the INPUT connector on the master cabinet using 12” passive speaker cabinets specifically designed a Speakon or ¼”...
Need help?
Do you have a question about the Gemini 1-P series and is the answer not in the manual?
Questions and answers