ELECTRICAL
DANGER
C-5.4 CHANGING THE ATTACHMENT
ATTENTION
Use only attachments directly manufactured or
recommended by Terexlift and detailed in the
"Optional attachments" section.
PROTECT THE
To change an attachment, operate as follows:
•
Drive to the place where you will release the
ENVIRONMENT
mounted attachment (when possible, a solid and
sheltered site).
•
Disconnect the quick connectors of the attachment
(if any), and connect the hydraulic locking pipes of
the attachments to couplings A.
IMPORTANT
•
Rest the attachment flat on the ground.
•
Pitch the attachment holding frame forward and
lower the boom to release the attachment upper
lock.
•
move back with the machine (or with the boom) and
drive to the new attachment to be coupled.
•
Hold the frame pitched forward and hook the upper
lock of the new attachment.
•
Retract and raise the attachment some centimetres.
It will centre automatically on the quick coupling
frame.
•
operate the control lever to lock the attachment.
•
Couple the connectors of the attachment, if any, to
the quick couplings of the frame.
Handler with telescopic boom GTH-3007
OPERATING INSTRUCTIONS
After substitution, visually check the attachment
is correctly coupled to the boom, before operating
the machine. A wrongly coupled attachment may
result in damage to persons or things.
C-32
Page
Document 57.0008.5200 - 10/2006
DANGER
DANGER
CAUTION
ELECTRICAL
DANGER
ATTENTION
PROTECT THE
ENVIRONMENT
IMPORTANT