Configuring Audio Driver Settings On The Daw Software; Recording/Playback - Steinberg UR12 Getting Started

Configuring Audio Driver Settings
on the DAW Software
This section provides examples of connecting the UR12 to
a computer.
Cubase Series Programs
Close your DAW software if it is running.
Move the [POWER SOURCE] switch on the
rear panel to the [USB2.0] side.
Connect the device directly to the computer
by using the included USB cable.
NOTE
(Windows only) Connect the USB cable to the same USB
port that you used when installing the Yamaha Steinberg
USB Driver. If you connect the USB cable to a different
USB port, the Yamaha Steinberg USB Driver will be
installed again.
Launch the Cubase series DAW.
When the [ASIO Driver Setup] window
appears while the Cubase series program is
launching, confirm that the device is
selected, then click [OK].
The audio driver settings are now complete.
Programs other than Cubase Series
Move the [POWER SOURCE] switch on the
rear panel to the [USB2.0] side.
Connect the device directly to the computer
by using the included USB cable.
NOTE
Connect only 1 device that supports the Yamaha Steinberg
USB Driver.
(Windows only) Connect the USB cable to the same USB
port that you used when installing the Yamaha Steinberg USB
Driver. If you connect the USB cable to a different USB port,
the Yamaha Steinberg USB Driver will be installed again.
Launch the DAW software.
Open the audio interface settings window.
(Windows only) Select the ASIO Driver for
the audio driver settings.
Set the ASIO Driver for Windows and audio
interface for Mac as follows.
Windows
Set the ASIO Driver settings to [Yamaha Steinberg USB
ASIO].
Mac
Set the UR12 to the appropriate audio interface
settings.
The audio driver settings are now complete.

Recording/Playback

Connect a microphone or guitar as shown in the
connection examples (page 9). Turn the [+48V] switch on
when using a phantom powered condenser microphone.
Cubase Series Programs
The [steinberg hub] window appears.
Select a project template in [Recording],
then click [Create].
The following example uses the [Clean E-Guitar +
Vocal] template.
NOTE
If the [Missing Ports] window appears, select a UR12 port for
each [Mapped ports].
Check [Map Always], and then click [OK]. By checking [Map
Always], the [Missing Ports] window will not appear again.
Select [Devices]  [VST Connections] and
open [VST Connections] window.
Using the UR12
UR12 Operation Manual 10