Page 2
YOUR CHECKLIST (besides the scooter itself) Keys Charger Tool kit: Open end wrench (8-10mm) , open end wrench (14-17mm) , open end wrench(14-17mm), Screwdriver, Allen wrench (6 mm), Allen wrench (3mm) Basket and parts:2 bolts BASKET ( M5X25 ) , connecting OPTIONAL.
ASSEMBLY INSTRUCTIONS 1. Take out the front and rear parts carefully. Place them on a flat, level surface. Place the foam provided or a block of wood of approximately 2 ½ “ to 3” thick under the front part of foot board to hold it in a horizontal position.
Page 4
4. Insert bolts(M10X55) and 5. Tighten the bolts and 6. Tighten self-locking bolts and nuts nuts. nuts using the open –end using Allen wrench (3mm). wrenches provided. IMPORTANT: Ensure that all 4 pairs of bolts and nuts are screwed on TIGHTLY. Failure to do this can be hazardous.
Page 5
11. Hold the connecting bracket Put the basket behind the onto the seat tube at the desired seat post. Place the connecting plate Screw the connecting plate and bracket against the connecting bracket. together using the screws and nuts provided. (2 bolts –...
Page 6
15. Plug in the power connection plugs and screw it tight. The pins of the two plugs are different. Ensure that the female and male connectors match. CHARGING THE BATTERY before you go… IMPORTANT: Charge the scooter overnight before your first use. It is advised that the unit to be fully charged (4-6 hours) and fully discharged (ride until the battery gauge indicates low battery) for the first three times to maximize the efficiency of the battery.
Page 7
CHECKLIST BEFORE YOUR FIRST RIDE Ensure that all screws, bolts and nuts are tightened properly. They may get loose during shipping and handling. Any loose screws, bolts or nuts could cause hazards. The Quickstart manual provides only the basic information to get started. Read the user’s manual carefully and thoroughly for operation of the scooter, before you start riding it.
Need help?
Do you have a question about the AGDH 3QQ and is the answer not in the manual?
Questions and answers