Summary of Contents for Boldrin Group Como
-
Page 1: Installation Instructions
Room controller Como Operating and Installation Instructions Please follow the safety information and read through these Instructions carefully before placing the system into operation. -
Page 2: Safety Information
The following status limb of persons and/or damage to can be accessed by operating the op- property. Como erating controls as shown or by per- forming the operation described. Power connection regulations corresponds to the requirements of the... -
Page 3: Operating Controls
Operating controls Operation Operation Operating controls Commissioning Correcting the desired room temperature Please do not forget: Remove the The rotary knob can be used to adjust protective film from the battery con- the programmed desired room tem- tacts (see Chapter Battery change). peratures by ±... -
Page 4: Frost-Protection Mode
Operating controls Operation Mode-selector switch Heating time changes Party key The heating time change is terminated In Reduced mode (ECO): : Change the operating mode. Takes effect after 3 seconds. by pressing the mode-selector switch Each time key is pressed, the heat- ing circuit switches to Heating mode i Frost-protection mode with the desired room temperature of... - Page 5 Operation Display A Plain-text display and time B 24h clock for display of the current heating times Como features a liquid-crystal display C Display of the current heating time (1-3) (LCD) displaying D Symbol for Holiday mode (frost protection) all relevant data.
- Page 6 Einstellwerte Operation Einstellwerte A Designation of the entry or of Changing the settings the operating level. Opening the hinged control panel cover B Entry causes the operation-control module to C Programming indicator switch automatically to Information and (Warning triangle E) Programming mode.
- Page 7 Einstellwerte Operating levels Operating levels Operating levels Heating Prog1 / Heating Prog2 Entry of the heating programs After you open the hinged control panel The BM allows entry of two heating 1) Open the hinged front panel -> Temperatures. cover (Info mode), you can choose six programs between which the user can different operating levels with the select.
- Page 8 Einstellwerte Operating levels times of the heating times. only time dependent. Parameter Display: Last time advance required Heating/Cooling Room sensor adaptation Setting: Maximum time advance The controller can also be used for The actual display can be varied by Control I/0 <=> Proportional controlled cooling of rooms.
- Page 9 Einstellwerte Operating levels Settings Parameter Designation Adjustment range Factory default LANGUAGE Parameter designation language D GB F NL E I CZ German ADAP ROOMT Room sensor adaptation -5°C - +5°C 0°C DES ROOMTEMP Current desired room temperature (including correction) Display only ANNOUNCE *) Choice of additional display OFF/ROOM SET T/...
-
Page 10: Installation Location
Accessories Operating levels Accessories Temperatures Holiday External room sensor RFB You can use the controller's Holiday Not in combination with AF program during the holiday period. The Display Adjustment Factory Installation location: range setting duration of the holiday and the holiday In the main controlled zone of the •... -
Page 11: For The Fitter
For the fitter Operating levels Battery change When the batteries reach a low charge state (M), the system switches to Heating mode. (Relay contact is closed -> burner / pump is on resp. valve is open). Always dispose of spent batteries properly (spent battery collection point). - Page 12 For the fitter Operating levels Errors RESET function In case of error function or to restore manufacturers set-up Error Error designation RESET: The controller performs a restart. The controller will work with E 80 Room sensor /AF defective the adjusted values. Only time and weekday have to be reset. Discontinuity/short circuit RESET + Ä...
Need help?
Do you have a question about the Como and is the answer not in the manual?
Questions and answers