HEAT GLO Radius Series Owner's Manual

Heat glo radius series wood stoves

Advertisement

Quick Links

Radius
Series Wood Stoves
Australian Owner's Manual • Installation and Operation
HEAT GLO.
No one builds a better fire
NOTE: This product is designed as an intermittent wood burner and not intended to be used as a primary heat source

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Radius Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for HEAT GLO Radius Series

  • Page 1 Radius Series Wood Stoves Australian Owner's Manual • Installation and Operation HEAT GLO. No one builds a better fire NOTE: This product is designed as an intermittent wood burner and not intended to be used as a primary heat source...
  • Page 2 Radius Series and Welcome to the Heat & Glo Family! Hearth & Home Technologies welcomes you to our tradition our stoves, inserts and fireplaces. And yet we are old-fash- of excellence! In choosing a Heat & Glo appliance, you ioned when it comes to craftsmanship. Each unit is meticu-...
  • Page 3: Table Of Contents

    Radius Series Table of contents Technical data ..................... Installation Safety Technical data and dimensions Type plate Dimension sketch for Radius - series Installation & Assembly ................. 7 Positioning your wood burning stove V e r t i c a l V e n t i n g H o r i z o n t a l...
  • Page 4 Technical data and dimensions Installation Materials: steel plate, cast iron, galvanized sheet, skamol The house owner is responsible for ensuring that all neces- Max. wood length: 30 cm sary national and local safety measures are observed during Weight Radius 300: ca.
  • Page 5: Technical Data

    TECHNICAL DATA Dimension Sketch - Radius 100 0144,0 C f , 40,1 353.0 43,4 179.8 Fig. 5.2: Left Side Fig. 5.3: Right Side Fig. 5.1: Front of Unit Fig. 5.5: Bottom of Unit Fig. 5.6: Top of Unit...
  • Page 6 TECHNICAL DATA Dimension Sketch Radius 300 0144,0 "4 '2,4 43.4 179.8 I 1r Fig. 6.2: Side of Unit Fig. 6.1: Front of Unit Fig. 6.4: Bottom of Unit Fig. 6.5: Top of Unit Fig. 6.3: Back of Unit 7076-260 • January 12, 2015...
  • Page 7 A. Positioning Your Wood Burning Stove the same fasteners. Install the venting per the venting The wood burning stove must be set up so the stove, flue manufactures specifications. Place the top cover plate connection, flue pipe, and chimney system can be cleaned (item "C"...
  • Page 8: Installation & Assembly

    INSTALLATION & ASSEMBLY This unit is suitable for installation in a shared flue. Component Pack Leveling the The component pack contains the following:  Manual Four leveling bolts have come installed on the unit. Following installation, adjustments can be made to the ...
  • Page 9 24 hours. Fuels The Radius Series wood stoves are designed to burn a This is a wood burning stove, the front, sides, and top will get wide range of firewood species. In general hardwoods are hot.
  • Page 10: Instruction For Use

    INSTRUCTION FOR USE Fig.10: Proper Fill and Startup Configuration Fig. 10.1: Add paper to back of firepot making sure to not block lower air inlet with paper. Fig. 10.2: Add small pieces of wood on top of paper allowing for air flow between pieces. Fig.
  • Page 11: Primary Air

    Secondary Air (holes in rear of firebox) Primary Air (Lower it Control) (Figure 11.1) This unit is equipped with a secondary combustion system that cannot be regulated. The purpose of this secondary The primary air is controlled by the lever on the left side of system is to provide air that will mix with the combustion the appliance.
  • Page 12: Front Door Seal

    the firebox through the air openings. When more air is Front Door Se& pulled into the fire, the fire burns hotter and is a cleaner The front door has a non-combustible rope which creates a burn. This also means that the burn time is shorter but tight seal for the firebox.
  • Page 13: Ash Drawer

    Ash Drawer Baffle Material (Figure 13.1) There are two baffle plates in the top of the unit. The Before attempting any maintenance on the unit ensure that purpose of these plates is to restrict and direct the the unit is cold and has no embers in the firebox. To access combustion gases to allow for complete combustion of the gasses prior to exiting the firebox and entering the flue.
  • Page 14 Removal of Radius refractory for service or rear venting conversion. Refractory that has been burned is fragile and must be handled carefully to prevent breakage. Remove Ash Drawer and set aside. 1. Using a pair of pliers; remove pin that secures the Firepot 2.
  • Page 15: Troubleshooting

    TROUBLESHOOTING Smoke escaping  Damp wood  Inferior firewood (waste wood, pallets etc.)  Chimney not drawing properly  Chimney not drawing sufficiently  Chimney is not properly dimensioned for the stove  Vacuum in room  Check if the smoke gas pipe/chimney are blocked Excessive soot build-up in chimney ...
  • Page 16: Service Parts & Accessories

    Service Parts & Accessories List Service Parts RADIUS-100 Beginning Manufacturing Date: Sept 2013 Wood Stove No one builds a better fire Ending Manufacturing Date: Active IMPORTANT: THIS IS DATED INFORMATION. Parts must be ordered from a dealer or distributor. Hearth and Home Technologies does Provide model number and serial number when requesting service parts from your dealer or distributor.
  • Page 17: Service Parts

    Service Parts & Accessories List Service Parts RArlUS-300 C3 11IMMIN-- HEAT Beginning Manufacturing Date: Sept 2013 Wood Stove Ending Manufacturing Date: Active No one builds a better fire IMPORTANT: THIS IS DATED INFORMATION, Parts must be ordered from a dealer or distributor. Hearth and Home Technologies does not sell directly to consumers.
  • Page 18: Warranty

    H E A R T 1 1 6 - H O M E technologies AUSTRALIAN WARRANTY INFORMATION Hearth & Home Technologies Inc (HHT) 1445 N. Highway I Colville, WA 99114 I (509-684-3745) HHT extends the following manufacturer's warranty for HHT gas, wood, pellet, coal and electric hearth appliances that are purchased from an HHT authorized dealer.
  • Page 19 OTHER RIGHTS The HHT manufacturer's warranty is in addition to other rights and remedies that you may have under Australian law. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage.
  • Page 20 H F A I : T H & H O _ technologies CONTACT INFORMATION: Hearth & Home Technologies 1445 North Highway Colville, WA 99114 Division of HNI INDUSTRIES We recommend that you record the following pertinent information for your heating appliance. Date purchased/installed: ________________________________________ Serial Number: __________________________________________________ Location on appliance: ___________________ Dealership purchased from: ________________________________________ Dealer phone: __________________________...

Table of Contents