Auto Configuration - Meridian DSP8000 User Manual

Auto configuration

In a system of Meridian products one of the products
acts as the controller for the system. It receives
infra-red commands from the MSR+ and then, if
appropriate, relays them to the other products in the
system via the Comms link.
The following automatic setup procedure should be
used to set up the Comms correctly between several
products:
•
Switch all the units to standby.
• Press Clear on the MSR+ remote.
Auto
Each unit will display:
One unit will then be designated as the controller.
Controller
The display shows:
All the other units will be configured as non-controllers.
Not Con.
The displays show:
If for any reason the automatic setup does not work,
make sure you are operating the remote from a
position where all the units can receive the infra-red,
and try again.
If this fails:
• Restore the default operation by selecting one of
the standard types; see To select a standard setting ,
page 4.
1
Setting up
the DSP8000
loudspeakers