Related Manuals for Naxa NAB-4002
Summary of Contents for Naxa NAB-4002
- Page 1 Instruction Manual NAB-4002 Wireless Audio Adapter with Bluetooth ® iPod /iPhone Dock and AUX Connectors ® ®...
- Page 2 At a Glance Power/Pair button USB charge port Line out jack Pair status Indicator Power Indicator 30-pin dock connector Press and hold the Power/Pair button to turn the unit on or off. Page 2 Naxa Electronics...
-
Page 3: Power Indicator
The initial charge will take approximately 2.5 Power Indicator hours. Charge the unit fully before use. Status Indicator Power off Light is off Power on Steady green light Charging Steady red light Low power Flashing green light www.naxa.com Page 3... - Page 4 Power/Pair button. Set the dock to iPod mode. (Refer to the manual of your dock for instructions.) 2) Connect the NAB-4002 to the dock. The dock connector [6] is found on the bot- tom of the unit. The NAB-4002 will turn on automatically and the pair status indicator [4] will flash slowly.
-
Page 5: Aux Input
Pair button [1] to turn the unit on. Note: If the unit does not turn on, the battery level may be too low. Connect the USB cable and charge the unit for at least 3 hours before trying again. www.naxa.com Page 5... - Page 6 Power/Pair button it and your Naxa device. This process is called once to place the unit in Pair mode. “pairing” and you will only have to do it once.
- Page 7 If you have problems with your device, please consult the instructions in this manual. Please also visit us on the web at www.naxa.com to get up to the minute news, alerts, and documen- tation for your device. For additional assistance, please contact Naxa Technical Support.
- Page 8 Naxa Electronics 2320 E 49th St Vernon, CA 90058 www.naxa.com...