Sound LAB G056F User Manual page 3

The SoundLab G056F turntable is designed to be used as a standard turntable plugged into a mixer or
as a USB turntable attached to a computer running the supplied Audacity software.
Before connecting the unit it is advised that you also consult your current equipment instruction
manual.
Do not situate the equipment near any sources of heat such as radiators, stoves or other appliances
that produce heat.
Do not place the unit in direct sunlight .
IMPORTANT: Be sure to turn off the equipment before you make any changes to the connections.
1. Connect the power cord to an AC outlet.
2. Connect the RCA cable to the PHONO input of your AMPLIFIER.
Output terminals Amplifier (Receiver)
L (White) L Channel
R (Red) R Channel
You can also use a line input by setting the phono / line switch at the rear of the turntable to line.
3. Connect PC via USB cord.
4. Push the On/Off Switch to turn on the power, the speed indicator and the strobe-illuminator,
which is located towards the front of the platter will light up.
5. Place a record on the slip mat. When playing a 45-rpm record with a large center hole, place
the 45-rpm adapter on the center spindle.
6. Set the speed to match the record.
7. Remove the stylus protector from the Headshell Stylus and then release the Tone arm clamp.
8. Set the cueing lever to the up position.
9. Press the Start/Stop Button; the turntable platter will start to rotate.
10. Move the tone arm over the desired groove.
11. Set the cueing lever to the down position, the tone arm will descend slowly onto the record
and begin playing.
12. When play is finished, raise the cueing lever, move the tone arm onto the Tone arm clamp.
13. Press the Start/Stop Button to stop the platter from rotating. Turn the On/Off Switch to off to
turn off the power.
14. SUSPEND PLAY
Set the cueing lever to the "UP" position during play, the stylus tip of the cartridge will lift from the
record.
Set Phono/Line
switch to "Line"
Set Phono/Line
switch to "Phono"